Motorola H102 User Manual - Page 17

Browse online or download pdf User Manual for Cordless Telephone Motorola H102. Motorola H102 26 pages. Dect 6.0

Print Page
NOTE
If pulse mode is selected, press TONE/* to switch from pulse to tone dialing
temporarily when dialing out. After the call is ended, the dial mode will
change back to pulse.
3.16

Setting the flash time

600MS
The default flash time is
. It is unlikely that you should need to change
this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU and then VOL+ or REDIAL/VOL- to select
3. Press MENU and then VOL+ or REDIAL/VOL- to the flash time you
want. (8 options are available:
4. Press MENU to save.
3.17

Setting the area code

1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU and then VOL+ or REDIAL/VOL- to select
3. Press MENU and enter the area code.
4. Press MENU to save.
3.18

Registration

Up to 5 handsets can be registered to one base. The original handset is
pre-registered to use. Additional handsets must be registered to the base
before you can use them.
To register an additional handset,
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU and then VOL+ or REDIAL/VOL- to select
Using the phone
SETUP BS
FLASH TIME
90
100
110
250
300
400
600
,
,
,
,
,
,
and
SETUP BS
AREA CODE
SETUP HS
REGISTRATION
3. Press MENU and then VOL+ or REDIAL/VOL- to select
YES
4. Select
and press MENU to enter the registration procedure as
below:
1. Press and hold FIND for 4 seconds on base, and then release.
2. Place the unregistered cordless handset on the charger.
3. A confirmation tone is generated if registration is successful.
HANDSET X
is displayed where
the phone goes back to idle.
.
To register an originally unregistered handset, follow steps 1 through 3
.
above.
700MS
)
3.19

To reset all settings

1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETTINGS
.
.
2. Press MENU and then VOL+ or REDIAL/VOL- to select
.
3. Press MENU to select
reset to default.
NOTE
All of your phonebook entries, calls list and redial list will remain
unchanged.
3.20

Paging/Find handset

Press FIND on the base. All handsets registered to the base will ring.
To stop the paging, press FIND again, or press any key on the handset, or
.
place the handset on the base.
.
X
denotes the number of handsets and
YES
. Then all the personalized settings will be
YES
NO
or
.
RESET
ALL SETTINGS
.
17