Motorola MCS 2000 Retrofit Instructions - Page 4

Browse online or download pdf Retrofit Instructions for Radio Motorola MCS 2000. Motorola MCS 2000 11 pages.
Also for Motorola MCS 2000: Installation Manual (14 pages), User Manual (20 pages)

Print Page

S-Hook Hole

(Four Places)

Reconfiguring Control

Head (Model I only)

Radio

Trunnion

S-Hook

Microphone

Cord

Figure 1 Microphone Cord S-Hook

Connected to Trunnion

3. Refer to Figure 2 and, at control head of radio, disconnect

microphone cord.

4. At rear of radio body, disconnect power and antenna cables.

5. At each side of radio, unscrew (counterclockwise) and remove the

wing screw that attaches radio body to radio trunnion.

6. Slide radio out of radio trunnion.

7. If only the control head of the radio is to be relocated and the

radio body is to remain where it is, skip the next two steps and

proceed to step 1 of the paragraph titled "Reconfiguring Control

Head" (Model I only or Models II and III only, as appropriate).

Otherwise, continue with next step.

8. Remove radio trunnion from its present location by removing the

four screws that attach it to vehicle.

9. Disconnect existing power cable from vehicle battery circuit. Then

remove power cable from vehicle.

1. In Installation Manual 68P02058U20, refer to section titled

"Control Head Remote Mount Installation".

2. Remove control head from radio body.

NOTE:

Microphone

Cord

Accessory

Connector

MAEPF-25537-O

Figure 2 Disconnecting Accessory

Plug and External Connections

The control head of the Model I radio

has a built-in loudspeaker. An external

loudspeaker can also be used with the

Model I radio. However, the

loudspeaker built-into the control

head and an external loudspeaker

cannot be used simultaneously. Step 3

below provides instructions for

Accessory

Plug

Control

Head

Bottom Side

of Radio

Radio

Chassis

Antenna

Cable

Power

Cable

MAEPF-25538-O

from Radio