Motorola XPR 4300 Installation Manual - Page 26

Browse online or download pdf Installation Manual for Radio Motorola XPR 4300. Motorola XPR 4300 45 pages.

Print Page

2-10

7. Give a final tug, by hand, to the collar, and retighten by hand as firmly as possible.

8. Slip the mini-UHF connector tool over the coaxial cable, using the gap between the tool's legs

(see

Figure

straight legs of the tool firmly together between your thumb and index finger and turn

clockwise (as shown) to tighten the collar. It should take 1/4 turn or less. When you feel the

tool slipping on the collar, the connection has been properly tightened. The tool can also be

used to loosen a tight collar.

NOTE: DO NOT use pliers or any other device to grip the tightening tool. It has been designed to

allow you to achieve the proper torque on the collar without overtightening. Overtightening the

collar can damage the connector and the radio.

2.6

Speaker

C a u t i o n

The speaker kit includes a trunnion bracket that allows the speaker to be mounted in a variety of

ways. With the trunnion bracket, the speaker can mount permanently on the dashboard or in

accessible firewall areas. The trunnion allows the speaker to tilt for best operation. Mount the

speaker out of the way so that it will not be kicked or knocked around by the vehicle occupants.

Mount the speaker as follows:

1. Use the speaker mounting bracket as a template to mark the mounting hole locations.

2. Use the self-drilling screws provided to fasten the trunnion.

3. Attach the speaker and fasten to the trunnion with two wing screws.

4. Route the speaker wires under the carpet or floor covering, or behind the kick panels. Be sure

the wires are out of the way and will not be snagged and broken by the occupants of the

vehicle.

March 23, 2006

2-31). Then, slide the tool up onto the plug's knurled collar. Squeeze the two

HLN6695_

CAUTION: DO NOT ground the radio's speaker leads. This system

has a floating speaker output (dc voltage on both leads); damage

to the audio circuit will result if either lead is grounded or if they are

shorted together.

(1) Squeeze

Firmly Together

Standard Configurations: Speaker

6816812H01