Acumen CAT21 User Manual - Page 4

Browse online or download pdf User Manual for Car Alarm Acumen CAT21. Acumen CAT21 13 pages. Acumen automobile alarm user guide

Print Page

The Remote Transmitter

T T h h i i s s b b u u t t t t o o n n w w i i l l l l ; ;
•
Arm & disarm the system,
•
Allow you to enter Diagnostic
and Service Modes.
T T h h i i s s b b u u t t t t o o n n w w i i l l l l ; ;
•
Allow the ignition key
to swivel out
Undo these screws (x3)
to remove cover and
replace batteries
Replacement battery type CR2016
T T h h i i s s b b u u t t t t o o n n w w i i l l l l ; ;

Ignition key

•
Deactivate/activate tilt
The system is supplied with 2 transmitter/Ignition keys, if a new
and vibration,
transmitter is supplied, a new key can be attached as shown in the
diagram opposite.
•
Select siren tone,
•
Select number of
When all three buttons are pressed at once and held
digits in PIN
for 5 seconds
W W i i t t h h i i g g n n i i t t i i o o n n o o f f f f - Silent arm/disarm is toggled (14 flashes on/7 off)
W W i i t t h h s s y y s s t t e e m m a a r r m m e e d d o o r r d d i i s s a a r r m m e e d d - on/off
W W i i t t h h i i g g n n i i t t i i o o n n o o n n , , s s y y s s t t e e m m d d i i s s a a r r m m e e d d - Nudge sensor toggled on/off
(6 flashes on/3 off)
W W i i t t h h i i g g n n i i t t i i o o n n o o f f f f , , s s y y s s t t e e m m i i n n s s e e r r v v i i c c e e m m o o d d e e - Indicators on warning
function is toggled on/off (5 flashes on/10 off)
Standard Settings of the system
T T h h i i s s b b u u t t t t o o n n w w i i l l l l ; ;
When the system arms, immobilisation and hot wire (ignition circuit
•
Activate the torch
becomes live) functions only will be enabled.
The system will arm automatically 50 seconds after the ignition is
switched off. (this time cannot be altered)
These screws (x2)
attach the ignition
You can manually arm the system by pressing the lock button. (You will
key to the transmitter
get 2 beeps and 2 flashes of the indicators) (see section 6)
To disarm the system, press the lock button. (You will get 1 beep and 1
flash of the indicators) (see section 6)
The system will arm with an audible warning of arming.
3