Epson 7800p - PowerLite XGA LCD Projector Product Information Manual - Page 18

Browse online or download pdf Product Information Manual for Software Epson 7800p - PowerLite XGA LCD Projector. Epson 7800p - PowerLite XGA LCD Projector 22 pages. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Also for Epson 7800p - PowerLite XGA LCD Projector: User Manual (42 pages), Operation Manual (36 pages), Quick Setup (2 pages), Replacement Parts (1 pages), Operation Manual (47 pages), Installation Manual (5 pages), Specification Sheet (2 pages), Technical Brief (7 pages), Product Support Bulletin (25 pages), Product Support Bulletin (22 pages), Product Support Bulletin (28 pages), Product Support Bulletin (41 pages), Product Support Bulletin (15 pages), Product Support Bulletin (22 pages)

Print Page

Epson 7800p - PowerLite XGA LCD Projector Product Information Manual

3. EMP NetworkManager connects to the projector, and you

see this screen:

Note: The projector must be plugged in (projecting or in

standby mode) for you to be able to connect to it.

To access a projector in standby mode, you must first select

as the

Network ON

Standby Mode

projector's Advanced1 menu. (See the User's Guide for

instructions.)

4. Verify that the network settings are correct. (If DHCP is

on, you don't need to verify network settings.)

Make any desired changes to the projector's network

address configuration (turning off DHCP enables the

manual settings).

You can give the projector a name up to 15 characters

long. Do not include the following symbols:

^ & ' . _ { } ~

Naming the projector helps you identify it in EMP

Monitor and EMP NetworkManager, especially if you're

managing a lot of them.

5. Click

Mail Notification Settings

6. Select

for the Mail Notification setting.

setting in the

! @ # $ %

. You see this screen:

5/03

EPSON PowerLite 7800p Projector

7. Enter the IP address and port number of the SMTP server

used for sending e-mail. (The port's default setting is 25,

but you can enter any number from 1 to 65535.)

8. Enter up to three destination e-mail addresses where you

want the event notification messages to be sent.

9. Click the

Setting a Notification Event

each address, then select the conditions under which you

want a message to be sent.

Note: A no-signal message is reported when no image signals

are being input to a projector. If the projector will not

normally be displaying an image, do not select 'no signal' as a

condition for which you want a message to be sent.

10. Click

, then click

Network Projector screen and confirm as needed.

11. When you see the test message window, you can send a

message with the heading "TEST MAIL" to the addresses

you have entered. The projector's name and IP address are

included in the body of the message.

12. When you're done making all your projector settings, close

EMP NetworkManager. (It does not have to be open for

messages to be sent or received.)

Understanding the Notification Messages

If a projector experiences a problem, it sends an e-mail

message to each of the addresses you provided using EMP

NetworkManager. The message includes the heading

"EPSON Projector" in the subject line. The body of the

message contains the name of the projector, the projector's IP

address, and a description of the problem. The problem

descriptions are similar to the errors reported by EMP

Monitor listed on page 15.

If a plus (+) sign appears before the description, it indicates

that a problem has occurred. A minus (–) sign appears when

the problem goes away or is resolved.

Note: If a projector develops a critical problem, it may not be

possible for it to report the error.

EPSON PowerLite 7800p Projector

button next to

again. Click

on the Setup for

Set