Epson 7850p - PowerLite XGA LCD Projector Product Information Manual - Page 24

Browse online or download pdf Product Information Manual for Software Epson 7850p - PowerLite XGA LCD Projector. Epson 7850p - PowerLite XGA LCD Projector 25 pages. Release of check tool for network projectors v1.00 for windows
Also for Epson 7850p - PowerLite XGA LCD Projector: User Manual (42 pages), Operation Manual (36 pages), User Manual (12 pages), Replacement Parts (1 pages), Operation Manual (47 pages), Product Support Bulletin (30 pages), Installation Manual (5 pages), Quick Setup (2 pages), Brochure & Specs (2 pages), Technical Brief (7 pages), Product Support Bulletin (25 pages), Product Support Bulletin (38 pages), Product Support Bulletin (12 pages), Product Support Bulletin (42 pages), Product Support Bulletin (22 pages), Product Support Bulletin (28 pages), Product Support Bulletin (41 pages), Product Support Bulletin (34 pages), Product Support Bulletin (38 pages), Product Support Bulletin (28 pages), Product Support Bulletin (15 pages), Product Support Bulletin (22 pages)

Print Page

Follow these steps to replace the lamp and air filters:

1. Turn off the projector.

2. When the P power light stops flashing, unplug the power

cord.

3. Let the projector cool for at least half an hour (if it has been

on). The lamp is extremely hot immediately after use.

4. Turn the projector upside-down and remove the air filters

at the side and bottom of the projector.

Lower the

handle

5. Insert the two new air filters. They should click into place.

6. To remove the lamp cover, insert the screwdriver supplied

with the spare lamp (or another flat-tipped screwdriver),

into the space beside the air vent to gently lift the lamp

cover off.

Insert the screwdriver here

Slide the filter

up here . . .

. . . and here

EPSON PowerLite 7850p Projector

7. Loosen the two screws holding the lamp in place. (You

don't need to remove them.)

8. Grasp the wire handle as shown and pull the lamp straight

out.

9. Gently insert the new lamp.

10. Once the lamp is fully inserted, tighten its screws and

replace the cover. (The projector won't come on if the lamp

cover is loose.)

11. Reset the lamp timer as described in the next section.

Resetting the Lamp Timer

After you replace the lamp, you need to reset the lamp timer

using the projector's About menu.

1. Press the

button on the remote control (or on the

projector's control panel). You see the main menu.

2. Use the

pointer button on the remote control (or the

arrow buttons on the projector) to highlight

press

Enter

6/03

EPSON PowerLite 7850p Projector

, then

About