Epson EasyMP Network Projection Operation Manual - Page 42

Browse online or download pdf Operation Manual for Software Epson EasyMP Network Projection. Epson EasyMP Network Projection 50 pages. Multimedia projector
Also for Epson EasyMP Network Projection: Operation Manual (47 pages), Update Instructions (4 pages), Operation Manual (50 pages), Operation Manual (47 pages), Operation Manual (50 pages), Operation Manual (40 pages), Operation Manual (48 pages), Operation Manual (47 pages)

Print Page

Troubleshooting

Check

Are the IP address, the subnet mask, and the gateway

address for the access point and the projector set

correctly?

(For Advanced Connection Mode)

Are the access point and the projector's subnet different?

(For Advanced Connection Mode)

Have you enabled DHCP?

(For Advanced Connection Mode)

When a connection is made using EasyMP Network Projection, the projected image remains as it is, and a connection

cannot be made from another computer.

Check

Did the presenter leave the conference room without

cutting off the network connection?

Check

Is EasyMP Network Projection set to start up using the

same connection mode?

When not using a DHCP, adjust each setting.

You can make the DHCP setting from the projector's Network menu.

See your projector User's Guide for details.

Select Manual search from EasyMP Network Projection, specify the IP address, and connect.

s "Specifying Either an IP Address or Projector Name and Performing a Search (Advanced

Connection Mode Only)"

p.17

When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby

status if an available DHCP server is not found.

With EasyMP Network Projection, the computer currently connected can be disconnected when

another computer tries to connect to the projector.

Therefore, when a Projector Keyword is not set for the projector, or if you know the Projector

Keyword, you can disconnect the computer currently connected and then connect your computer to

the projector.

When a Projector Keyword is set for the projector and you do not know the Projector Keyword, restart

the projector and reconnect.

Select Display Connection Mode Selection window on startup on the General settings tab from

Set options. The projector selection screen is displayed after restarting EasyMP Network Projection.

Remedy