Troubleshooting
Check
Is Wireless LAN Power set to Off in the Wireless LAN menu from
the projector's Configuration menu?
Is the AirMac setting for Mac OS correct?
Cannot connect in Advanced Connection Mode.
Check
Is the SSID setting different?
Is the same WEP key set?
Are the connection denial functions, such as MAC Address
restrictions and port restrictions, set correctly at the access point?
Are the IP address, the subnet mask, and the gateway address for
the access point and the projector set correctly?
Are the access point and the projector's subnet different?
Have you enabled DHCP?
Set Wireless LAN Power to On in the Wireless LAN menu from the Configuration menu.
See the following manual for details on the projector's wireless LAN settings.
User's Guide "Wireless LAN menu"
s
Check that AirMac is set to on. Or, check whether an appropriate access point has been selected.
Set the computer, the access point, and the projector to the same SSID.
You can make the SSID setting from the projector's Network menu.
See the following manual for details.
User's Guide "Wireless LAN menu"
s
When selecting WEP from Security, set the access point, the computer, and the projector to the same WEP key.
See the following manual for details on the WEP key.
User's Guide "Security menu"
s
g
Set connection permission at the access point to allow projectors to connect.
When not using a DHCP, adjust each setting.
You can make the DHCP setting from the projector's Network menu.
See the following manual for details.
User's Guide "Network Menu (EB-1775W/EB-1770W/EB-1760W Only)"
s
Select Manual search from EasyMP Network Projection, specify the IP address, and connect.
s "Specifying Either an IP Address or Projector Name and Performing a Search (Advanced Connection Mode
Only)"
p.16
When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby status if an
available DHCP server is not found.
Remedy
Remedy
39
Print Page