Product Support Bulletin
Subject: DOS Device Driver and Interface Connection Diagnostic
for the Epson ES-300C Scanner
Date: 4/3/92
Page(s): 1 of 1
This bulletin was made for the purpose of announcing the availability of a DOS
device driver and interface connection diagnostic for the Epson ES-300C Scanner.
The ES-300C DOS Device Driver was developed for the purpose of allowing third
party scanner application programs to send I/O routines to the device driver instead
of writing to a specific hardware interface. The DOS Device Driver supports the
Epson Bi-Directional Parallel Interface, the IBM PS/2 Internal Parallel Interface, and
Adaptec SCSI interfaces. For information regarding how to obtain this driver, refer
to the distribution information below. If you require additional specifications on the
DOS Device Driver call the Epson Imaging Product Support Department.
The ES-300C Scanner Interface Connection Diagnostic works in conjunction with
the DOS device driver to allow quick and easy verification of the interface
connection between the scanner and host computer. The diagnostic works from
DOS, and does not require Microsoft Windows. Once the diagnostic is initiated, the
scanner will complete a page scan in less than 60 seconds on most computers.
DISTRIBUTION
The Epson ES-300C DOS Device Driver and Scanner Interface Connection
Diagnostic software are available from 4 sources:
A diskette containing all the files are included in each ES-300C DOS interface
1)
kit. The Epson Product Code for the kit is ES300DOS-A.
2)
The files are available from the Epson BBS. The self-extracting file name is
ES300DD.EXE. The Epson BBS telephone number is (310) 782-4531.
The CompuServe Bulletin Board has the files located in the Epson Forum.
3)
After logging into CompuServe, type 'GO EPSON" at the prompt to access the
Epson Forum.
Any Premier or Standard Epson Customer Care Center can order the diskette
4)
from our Parts Order Services Department. The diskette part number is
ES3DISK.
PSB No: P-0086
Originator: RSS
Print Page