Toshiba 13 Owner's Manual - Page 5

Browse online or download pdf Owner's Manual for Air Conditioner Toshiba 13. Toshiba 13 6 pages. Split type

Print Page

Setting Daily Timer

Press

: Set the ON timer.

Press

: Set the OFF timer.

• During the daily timer is activating, both arrows ( , ) are indicated.

Note:

• Keep the remote control in accessible transmission to the indoor unit;

otherwise, the time lag of up to 15 minutes will occur.

• The setting will be saved for the next same operation.

PRESET OPERATION

Set your preferred operation for future use. The setting will be memorized by

the unit for future operation (except airﬂ ow direction).

1. Select your preferred operation.

2. Press and hold

The P mark displays.

3. Press

: Operate the preset operation.

AUTO RESTART OPERATION

To automatically restart the air conditioner after the power failure (Power of

the unit must be on.)

Setting

1. Press and hold the RESET button on the indoor unit for 3 seconds to

set the operation. (3 beep sound and OPERATION lamp blink 5 time/

sec for 5 seconds)

2. Press and hold the RESET button on the indoor unit for 3 seconds to

cancel the operation. (3 beep sound but OPERATION lamp does not

blink)

• In case of ON timer or OFF timer are set, AUTO RESTART

OPERATION does not activate.

QUIET OPERATION

To operate at super low fan speed for quiet operation (except in DRY mode)

Press

: Start and stop the operation.

Note: Under certain conditions, QUIET operation may not provide adequate

cooling due to low sound features.

COMFORT SLEEP OPERATION

For comfortable sleep, automatically control air ﬂ ow and automatically turn

OFF.

Press

: Select 1, 3, 5 or 9 hrs for OFF timer operation.

Note: The cooling operation, the set temperature will increase automatically

1 degree/hour for 2 hours (maximum 2 degrees increase). For heating

operation, the set temperature will decrease.

MAINTENANCE

Firstly, turn off the circuit breaker.

Filter Reset

FILTER lamp lights on; the ﬁ lter must be cleaned.

To turn off the lamp, push the RESET button on the indoor unit or the FILTER

button on the remote control.

Indoor Unit and Remote Control

• Clean the indoor unit and the remote control with a wet cloth when

needed.

• No benzine, thinner, polishing powder or chemically-treated duster.

SELF CLEANING OPERATION (COOL

AND DRY OPERATION ONLY)

To protect bad smell caused by the humidity in the indoor unit.

1. If the

button is pressed once during "Cool" or "Dry" mode,

the fan will continue to run for other 30 minutes, then it will turn off

automatically. This will reduce the moisture in the indoor unit.

2. To stop the unit immediately, press the

within 30 seconds.

Press

button during

the ( or ) mark ﬂ ashing.

for 3 seconds to memorize the setting.

more 2 times

OPERATION AND PERFORMANCE

1. Three-minute protection feature: To prevent the unit from being activated

for 3 minutes when suddenly restarted or switched to ON.

2. Preheating operation: Warm up the unit for 5 minutes before blowing

warm air.

3. Warm air control: When the room temperature reaches the set

temperature, the fan speed is automatically reduced and the outdoor unit

will stop.

4. Automatic defrosting: Fans will stop during defrost operation.

5. Heating capacity: Heat is absorbed from outdoor and released into

the room. When the outdoor temperature is too low, use another

recommended heating apparatus in combination with the air conditioner.

6. Consideration for accumulated snow: Select the position for outdoor unit

where it will not be subjected to snow drifts, accumulation of leaves or

other seasonal debris.

7. Some minor cracking sound may occur when unit operating. This is

normal because the cracking sound may be caused by expansion/

contraction of plastic.

Note: Item 2 to 6 for Heating model

Air conditioner operating conditions

Temp.

Outdoor Temperature

Operation

Heating

–15°C ~ 24°C

Cooling

–10°C ~ 46°C

Dry

–10°C ~ 46°C

TROUBLESHOOTING (CHECK POINT)

The unit does not operate.

• The power main switch is

turned off.

• The circuit breaker is

activated to cut off the power

supply.

• Stoppage of electric current

• ON timer is set.

REMOTE CONTROL A-B SELECTION

To separate using of remote control for each indoor unit in case of 2 air

conditioners are installed nearly.

Remote Control B Setup.

1. Press RESET button on the indoor unit to turn the air conditioner ON.

2. Point the remote control at the indoor unit.

3. Push and hold

button on the Remote Control by the tip of the

pencil. "00" will be shown on the display.

4. Press

during pushing

"00" will disappear and the air conditioner will turn OFF. The Remote

Control B is memorized.

Note: 1. Repeat above step to reset Remote Control to be A.

2. Remote Control A has not "A" display.

3. Default setting of Remote Control from factory is A.

Room Temperature

Less than 28°C

21°C ~ 32°C

17°C ~ 32°C

Cooling or Heating is abnormally low.

• The ﬁ lters are blocked with dust.

• The temperature has been set

improperly.

• The windows or doors are opened.

• The air inlet or outlet of the outdoor

unit is blocked.

• The fan speed is too low.

• The operation mode is DRY.

. "B" will show on the display and