ECKey EK6 series Installer's Manual - Page 3

Browse online or download pdf Installer's Manual for IP Access Controllers ECKey EK6 series. ECKey EK6 series 9 pages. Internal/external mounting – red and green led control from access control system
Also for ECKey EK6 series: Nstallation And Operation Manual (15 pages)

Print Page
How do I Install ECKey?
You will need an access control system or door controller that accepts 26 bit Wiegand messages.
Connect the Green wire to the Wiegand Data 0 and White wire to the Wiegand Data 1 to your Access System or Door Controller. These can be connect
in parallel to an existing 26 Bit Wiegand card reader.
By default the range is 1-3metres. Use the management application for other range settings. An optional Administration Light can be connected to the
Orange wire and ground.
LED control
On the EK6-0D the Red and Green Colors of the Administration Light can be controlled from any external access control system. If the Pink wire is
connected to Ground the status light will be Red. If the Purple is connected to Ground the status light will be Green. On both models the Blue
Administration Light is mirrored on the External Light is used to indicate a Wiegand message has been sent and for ECKey Administration.
Model
EK6-0D
Wiring
Purple and Pink not
connected
Power on
Red
Searching
Red
Send Wiegand Message
Blue for 5 seconds
Access Success as reported by
None
access control system
Access Failure as reported by
None
access control system
Pairing
Blue flashing quickly every
second
Administration
Blue triple flashing
External Light
As the Blue of the Status Light
How do I register my phone from an access control system?
1.
Set up your access control system as you would to register a Wiegand card with the ECKey unit connected.
2.
Make your phone discoverable (visible) by consulting your phone documentation (usually in Setting -> Connectivity-> Bluetooth-> Find Me or
Setup).
3.
With the Bluetooth phone in range a virtual Wiegand card number will be sent to the access control system with a site or facilities code of
250.
4.
Follow the instructions of the access control panel to accept this virtual Wiegand card number and associate access rights to it.
How to I register my phone from a computer?
1.
You will require the Bluetooth phone that is to be registered and Windows XP or Vista machine with Bluetooth capability.
2.
Make your phone discoverable (visible) by consulting your phone documentation (usually in Setting -> Connectivity-> Bluetooth-> Find Me or
Setup).
Wire
Red
Black
Green
White
Yellow
Blue
Brown
Orange
Grey
Purple
Pink
Tan
EK6-0D
Purple connected to Green output and Pink
connected to Red output of access control system
Red
None
Blue for 5 seconds or until a success or failure is
received.
Green
Red
Blue flashing quickly every second
Blue triple flashing
As the Blue of the Status Light
Model: EK6 Install Guide
Description
AC/DC Supply (V+)
EK6-0C 12 to 24 VDC
EK6-0D 12 to 24 VDC/AC
Ground (G)
Ground power supply
Administration Button 2
External Blue LED ground
Wiegand Data 0
Data 0
Wiegand Data 1
Data 1
Relay Common (C)
As required
Relay N/C (NC)
As required
Relay N/O (NO)
As required
External Status Light (L)
External Blue LED positive output
Administration Button (B)
Administration Button 2
Green LED
Optional Green LED Enable when it is
pulled to ground by Access Control
System
Red LED
Optional Red LED Enable when it is
pulled to ground by Access Control
System
AC Input
As required
EK6-0D
Purple connected to Green output of access control
system and Pink connected to ground
Red
Red
Blue for 5 seconds or until a success or failure is received.
Green
Red
Blue flashing quickly every second
Blue triple flashing
As the Blue of the Status Light