Epson PowerLite 61p Product Information - Page 12

Browse online or download pdf Product Information for Software Epson PowerLite 61p. Epson PowerLite 61p 15 pages. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Also for Epson PowerLite 61p: User Manual (42 pages), Specifications (2 pages), Operation Manual (47 pages), Quick Setup Manual (2 pages), Parts List (1 pages), Lamp Replacement Update (2 pages), Installation Manual (19 pages), Product Support Bulletin (25 pages), Product Support Bulletin (8 pages), Product Support Bulletin (22 pages), Product Support Bulletin (28 pages), Product Support Bulletin (41 pages), Product Support Bulletin (15 pages), Product Support Bulletin (22 pages)

Print Page

Epson PowerLite 61p/81p Projector

3. Turn the projector upside-down and clean the filter and air

intake vents on the base of the projector.

Air vent

If dirt is difficult to remove or the filter is torn, replace it.

The air filter set (part number V13H134A06) contains two

filters. Contact your dealer or call Epson at (800) 873-7766

to obtain a new set. In Canada, please call (800) 463-7766 to

locate a dealer.

Note:

When you get a replacement lamp for your projector, a new air

filter is included. Replace the filter when you replace the lamp.

4. If you need to replace the filter, slide it off as shown.

5. Align the new filter carefully as you slide it in until it clicks

into place.

Epson PowerLite 61p/81p Projector

Replacing the Lamp

The projection lamp typically lasts for about 2000 hours of use

(in high brightness mode) or 3000 hours (in low brightness

mode). It is time to replace the lamp when:

Air vent

The projected image gets darker or starts to deteriorate.

The

The message

the lamp comes on. To maintain brightness and image

quality, replace the lamp as soon as possible.

Air filter

Note:

You can check how many hours the lamp has been used in the Info

menu.

Note:

Turn the projector off when not in use. Coninuous use may reduce

the overall life of the product.

Contact your dealer or call Epson at (800) 873-7766 in the

United States for a replacement lamp. Request part number

V13H010L30

dealer.

Follow these steps to replace the lamp:

1. Press the P Power button twice to turn off the projector.

When you hear the projector beep twice, unplug the power

cord.

2. If the projector has been on, allow it to cool down for at least

half an hour (or until the lamp is cool).

Warning:

Let the lamp cool before replacing it. If the lamp breaks, handle

the shards carefully to avoid injury.

3. Use the screwdriver included with the replacement lamp to

loosen the screw holding the lamp cover (located on top of

the projector).

4. Slide the cover out, then lift it off.

6/04

warning light is flashing orange.

appears on the screen when

Replace the Lamp

. In Canada, please call (800) 463-7766 to locate a