Epson PowerLite 99W Quick Setup - Page 3
Browse online or download pdf Quick Setup for Software Epson PowerLite 99W. Epson PowerLite 99W 4 pages. Warranty statement
Also for Epson PowerLite 99W: Operation Manual (48 pages), Operation Manual (47 pages), Declaration Of Conformity (4 pages), Installation Handbook (2 pages)
4
Attach the wireless LAN module cover and secure it using the screw you
removed.
5
Press the Menu button on the remote control, select the Network menu,
and press
.
6
Choose Network Configuration and press
7
Select the Wireless LAN menu and press
8
Choose Connection Mode, press
connection to a computer, tablet, or smartphone) or Advanced (for
a connection to a router or access point), then press
you're finished, press Esc to return to the Wireless LAN menu.
9
If you chose the Advanced connection mode, select SSID, press
enter your network name (SSID) on the screen that appears.
•
To select a number or character, use the arrow buttons on the remote
control to highlight it, then press
•
To switch between uppercase and lowercase letters, select CAPS and
press
.
•
To change the displayed symbols, select SYM1 or SYM2 and
press
.
When you're finished entering the SSID, select Finish and press
10
If you chose the Advanced connection mode, select IP settings and
press
.
If your network assigns addresses automatically, turn on DHCP. If not,
turn off DHCP and enter the projector's IP Address, Subnet Mask, and
Gateway Address, as needed.
To enter numbers, use the arrow buttons on the remote control to
highlight a number, then press the
entering an address, highlight Finish, then press
.
.
, select Quick (for a direct
again. When
and
.
.
button. When you're finished
. Press Esc.
11
To prevent the SSID and IP address from appearing on the network
standby screen, set the SSID Display and IP Address Display
settings to Off.
12
When you're finished selecting settings in the Wireless LAN menu,
press Esc.
13
If you are connecting the projector to a secure network, select the
Security menu and press
you're finished.
14
Select Complete and press
save your settings.
15
See "Install network software" for additional instructions.
Project over a wired
network
Follow the steps here to configure your projector for your wired network using
the projector's menu system.
1
Plug in and turn on the projector.
2
Press the Menu button on the remote control, select the Network menu,
and press
.
3
Select Network Configuration and press
4
Select the Basic menu and press
5
Select the Projector Name setting and enter a name (up to 16 characters
long) to identify your projector over the network.
Use the displayed keyboard to enter characters. Press the arrow buttons
on the remote control to highlight the characters and press
them.
Note: See the online User's Guide for information on adding passwords.
. Then select settings and press Esc when
, then select Yes and press
.
.
again to
to select