Epson PowerLite D6250 Operation Manual - Page 41

Browse online or download pdf Operation Manual for Software Epson PowerLite D6250. Epson PowerLite D6250 50 pages. Air filter and vent maintenance
Also for Epson PowerLite D6250: Quick Setup Manual (4 pages), Declaration Of Conformity (4 pages), Brochure (6 pages), Maintenance Manual (4 pages), Installation Handbook (4 pages), Installation Handbook (4 pages), Installation Handbook (3 pages)

Epson PowerLite D6250 Operation Manual
Troubleshooting

Cannot connect the projector and the computer via wired LAN.

Check
Are the computer's LAN card and the built-in LAN function
available?
Is the network cable connected correctly?

Cannot connect the projector and the computer via the network.

Check
Is the network configuration screen displayed on the
projector?
Was the network adapter used selected correctly with
EasyMP Network Projection?
Is the firewall turned off, or has the firewall been
registered as an exception?
Is the SSID setting different?
(For Advanced Connection Mode)
Are the connection denial functions, such as MAC
Address
g
restrictions and port restrictions, set correctly at
the access point?
(For Advanced Connection Mode)
Check that LAN is available from the device manager under Control Panel - System - Hardware.
Check that the network cable is connected correctly. Reconnect it if it is not connected or not
connected properly.
Close network settings on the projector, and return to the LAN standby screen. If the network
configuration screen is displayed on the projector, you cannot connect using EasyMP Network
Projection.
If the computer has multiple LAN environments, it cannot connect unless the network adapter is
selected correctly. When using a computer running Windows, start EasyMP Network Projection and
select the network adapter you are using from Set options - Switch LAN.
s "General settings tab"
p.34
When you do not wish to turn off the firewall or register the firewall as an exception, make the
necessary settings to open the ports.
The ports used by EasyMP Network Projection are "3620", "3621", and "3629".
Set the computer, the access point, and the projector to the same SSID.
You can make the SSID setting from the projector's Network menu.
See your projector User's Guide for details.
Set connection permission at the access point to allow projectors to connect.
Remedy
Remedy
41