Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Assembly And Set-Up Manual - Page 8

Browse online or download pdf Assembly And Set-Up Manual for Software Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine. Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine 14 pages. Product support bulletin
Also for Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine: Brochure & Specs (8 pages), Specification Sheet (8 pages), Quick Installation Manual (34 pages), Product Information (17 pages), Quick Reference (10 pages), Specifications (4 pages), Product Support Bulletin (44 pages)

Print Page
Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Assembly And Set-Up Manual
2. Attach the three clamps packed with your
printer, then route the power cord through the
clamps at the rear of the printer.
3. Check the label on the back of the printer to
make sure the voltage required by the printer
matches that of the electrical outlet you are
using.
4. Plug the power cord into a properly grounded
electrical outlet.
c
Caution:
Do not use an outlet that is controlled by an
automatic timer or wall switch. Otherwise,
accidental shut down or damage to your
printer may occur.

Installing the Ink Cartridges

w
Warning:
The ink cartridges are self-contained units.
Under ordinary use, ink will not leak from the
cartridges. If ink does get on your hands, wash
them thoroughly with soap and water. If ink gets
into your eyes, flush them immediately with
water.
1. Turn on the printer by pressing the Power
button. After a short time NO INK CARTRIDGE
is displayed on the LCD panel.
6
2. Push the ink compartment cover to open it.
3. Put the attached label for your ink type on the
back of the ink compartment cover.
4. Push the top of the clamp, and pull it forward.
5. Remove the package from an ink cartridge.
Note:
If you use UltraChrome or ColorFast ink
cartridges, shake the ink cartridge gently before
installing it for best results.
c
Caution:
Do not shake cartridges that have been
installed previously.