Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst Network Manual - Page 41

Browse online or download pdf Network Manual for Software Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst. Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst 46 pages. Warranty statement
Also for Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst: Specification Sheet (6 pages), Getting Started (13 pages), Brochure & Specs (6 pages), Setup Manual (16 pages), Quick Reference Manual (12 pages), Installation Manual (4 pages), Product Information Manual (16 pages), Limited Warranty (12 pages)

Print Page

Chapter 5

Tips for Administrator

These items are used to make network settings on the printer's control panel.

Item

NETWORK SETUP

IP ADDRESS SETTING*

IP*

SM*

DG or GW*

Bonjour*

INIT NETWORK

SETTING*

* Available only when Enable is selected for NETWORK SETUP.

Follow the steps below to set the IP address using the arp/ping command.

Note:

❏ Make sure that the Set using PING function is enabled on the TCP/IP menu in EpsonNet

Config. If this function is disabled, you cannot set the IP address using the arp/ping command.

❏ Make sure the network interface and the computer are in the same segment.

Before you start, you need the following information:

❏ A valid IP address for the network interface. Ask your network administrator for an

IP address which does not cause conflicts with any other device on the network. If

you are the network administrator, choose an address within your subnet which does

not conflict with any other device.

❏ The MAC (Ethernet hardware) address of the network interface. You can find out the

MAC address on a status sheet.

Settings (default in bold)

Disable, Enable

Auto, Panel

0.0.0.0 to 255.255.255.255

On, Off

EXECUTE

Tips for Administrator