MSI Wind Top AE2010 User Manual - Page 4

Browse online or download pdf User Manual for Laptop MSI Wind Top AE2010. MSI Wind Top AE2010 40 pages. Ms-6650 (v1.x) system
Also for MSI Wind Top AE2010: Quick User Manual (2 pages)

Print Page
MSI Wind Top AE2010 User Manual
▍
Preface

Safety Instructions

1.
Always read the safety instructions carefully.
2.
Keep this user's manual for future reference.
3.
Keep this equipment away from humidity.
4.
Lay this equipment on a reliable flat surface before setting it up.
5.
The ventilator on the enclosure is used for air convection and to prevent the equipment from
overheating. Do not cover the ventilator.
6.
Check the AC input: 100-240V~, 50-60Hz, 1.5A
7.
Check the DC output: 19V
8.
Make sure that the power voltage is within its safety range and has been adjusted properly to
the value of 100~240V before connecting the equipment to the power inlet.
9.
Place the power cord in a way that people are unlikely to step on it. Do not place anything on
the power cord.
10.
Always unplug the power cord before inserting any add-on card or module.
11.
All cautions and warnings on the equipment should be noted.
12.
Never pour any liquid into the opening that could damage or cause electrical shock.
13.
If any of the following situations arises, get the equipment checked by service personnel:
￭
The power cord or plug is damaged.
￭
Liquid has penetrated into the equipment.
￭
The equipment has been exposed to moisture.
￭
The equipment does not work well or you can not get it work according to user's manual.
￭
The equipment has dropped and damaged.
￭
The equipment has obvious sign of breakage.
◙
DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT UNCONDI-TIONED, STOR-
AGE TEMPERATURE ABOVE 40
WARNING:
1.
For every changes in power cord's usage, please use an approved power cord with condition
greater or equal to H05VV-F, 3G, 0.75mm2.
2.
Internal part is hazardous moving parts, please keep fingers and other body parts away.
3.
For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be
easily accessible.
4.
Do not disable the protective earth pin from the plug, the equipment must be connected to an
earthed mains socket-outlet.
5.
Adjustment of the volume control as well as the equalizer to other settings than the center
position may increase the ear-/ headphones output voltage and therefore the sound pressure
level.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer.
廢電池請回收
For better environmental protection, waste batteries should be collected
separately for recycling or special disposal.
1.
The optical storage devices are classified as CLASS 1 LASER PRODUCT. Use of
controls or adjustments or performance of procedures other than those specified
is prohibited.
2.
Do not touch the lens inside the drive.
4.74A
o
C (102
o
F), IT MAY DAM-AGE THE EQUIPMENT.
iv