1. Important
brightness, avoid the fluorescent
lighting, and surfaces that don't
reflect too much light.
• Seeing a doctor if your symp-
toms.
Maintenance
• To protect your monitor from pos-
sible damage, do not put excessive
pressure on the LCD panel. When
moving your monitor, grasp the
frame to lift; do not lift the monitor
by placing your hand or fingers on
the LCD panel.
• Unplug the monitor if you are not
going to use it for an extensive pe-
riod of time.
• Unplug the monitor if you need to
clean it with a slightly damp cloth.
The screen may be wiped with a
dry cloth when the power is off.
However, never use organic solvent,
such as, alcohol, or ammonia-based
liquids to clean your monitor.
• To avoid the risk of shock or perma-
nent damage to the set, do not ex-
pose the monitor to dust, rain, water,
or excessive moisture environment.
• If your monitor gets wet, wipe it with
dry cloth as soon as possible.
• If foreign substance or water gets in
your monitor, please turn the power
off immediately and disconnect the
power cord. Then, remove the for-
eign substance or water, and send it
to the maintenance center.
• Do not store or use the monitor in
locations exposed to heat, direct
sunlight or extreme cold.
• In order to maintain the best per-
formance of your monitor and use
it for a longer lifetime, please use
the monitor in a location that falls
within the following temperature
and humidity ranges.
• Temperature: 0-40°C 32-104°F
• Humidity: 20-80% RH
• IMPORTANT: Always activate a mov-
ing screen saver program when you
leave your monitor unattended.
Always activate a periodic screen
refresh application if your monitor
will display unchanging static con-
tent. Uninterrupted display of still
or static images over an extended
period may cause "burn in", also
known as "after-imaging" or "ghost
imaging", on your screen.
• "Burn-in", "after-imaging", or "ghost
imaging" is a well-known phenom-
enon in LCD panel technology.
In most cases, the "burned in" or
"after-imaging" or "ghost imag-
ing" will disappear gradually over a
period of time after the power has
been switched off.
Warning
Failure to activate a screen saver, or
a periodic screen refresh application
may result in severe "burn-in" or "after-
image" or "ghost image" symptoms
that will not disappear and cannot be
repaired. The damage mentioned above
is not covered under your warranty.
Service
• The casing cover should be opened
only by qualified service personnel.
• If there is any need for any docu-
ment for repair or integration,
please contact with your local
service center. (please refer to the
chapter of "Consumer Information
Center")
• For transportation information,
please refer to "Technical Specifica-
tions".
• Do not leave your monitor in a car/
trunk under direct sun light.
2
Print Page