Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C User Manual - Page 24
Browse online or download pdf User Manual for Stereo System Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C. Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C 31 pages. 3 cd changer with dolby® pro logic processor, five loudspeakers, 320 watts total power
Also for Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C: Specifications (2 pages), Manual (31 pages)
Print Page
TAPE
3a(for playback on tape deck 2 only)
• Press í or ë to select tape side (see
Tape Side) .
• Press A. REV to select the different type
of playback mode (see Auto Reverse
Playback) .
4 Press Ç to end playback.
™ "T1 or T2" with "! ! ! or @ @ @"
will be displayed.
Note:
– When the tape has stopped playing, the
system will switch to standby mode
after 30 minutes if no button is pressed.
Rewind/Fast Forward
When playback is stopped
1 You can rewind or fast forward the tape
by pressing à or á respectively.
™ If rewinding, "T1 ! or T2 !" with
"!" scrolling left will be displayed.
™ If fast forwarding, "T1 @ or
T2 @" with "@" scrolling right will be
displayed
™ The tape will stop automatically at
the end of the rewinding or fast
forwarding.
2 Press Ç to stop rewinding or fast
forwarding.
24
pg 01-31/P88/22-Eng
24
During playback
• Press and hold à or á until the
desired passage is located.
™ "T1 or T2" with "! ! or @ @"
scrolling left or right will be
displayed depending on which button
is pressed.
™ During searching, the sound is
reduced to a low volume.
™ When you release à or á, the
tape continues playing.
Notes:
– During rewinding or fast forwarding of a
tape, it is also possible to select another
source (e.g. CD, TUNER, or AUX).
– Before playing a tape, check and tighten
slack tape with a pencil. Slack tape may
get jammed or may burst in the
mechanism.
– C-120 tape is extremely thin and is
easily deformed or damaged. It is not
recommended for use in this system.
– Store the tapes at room temperature
and do not put them too close to a
magnetic field (for example, a
transformer, TV, or speaker).
Dolby B Noise Reduction
System
1 Press DOLBY B NR to switch on Dolby
B NR.
™ The d B NR appears in the display.
2 Press DOLBY B NR again to switch off
Dolby B NR.
™ The d B NR disappears from the
display.
Note:
– A tape recorded with the Dolby B NR
system should also be played in the
Dolby B NR mode. If you forget to
operate the DOLBY B NR button, the
treble may be reproduced too strongly.
.
3/6/00, 1:27 PM
3139 116 19721