Philips 7000 series User Manual - Page 13

Browse online or download pdf User Manual for Stereo System Philips 7000 series. Philips 7000 series 40 pages. Cordless vacuum
Also for Philips 7000 series: Quick Start Manual (24 pages), Quick Start Manual (16 pages), Quick Start Manual (17 pages), Quick Start Manual (17 pages), Quick Start Manual (17 pages), Information (3 pages), Brochure & Specs (3 pages), Brochure & Specs (3 pages), Quick Start Manual (20 pages), Quick Start Manual (8 pages), User Manual (32 pages), User Manual (18 pages), Manual (36 pages), Quick Start Manual (2 pages), Quick Start Manual (20 pages), User Manual (14 pages), Manual (33 pages), User Manual (12 pages), User Manual (12 pages), User Manual (20 pages), User Manual (23 pages), Manual (15 pages), Manual (16 pages), User Manual (20 pages), Troubleshooting Manual (7 pages), User Manual (22 pages), User Manual (15 pages), User Manual (14 pages), User Manual (32 pages), User Manual (49 pages), User Manual (22 pages), User Manual (18 pages), User Manual (17 pages), User Manual (20 pages), User Manual (21 pages), Frequently Asked Questions Manual (7 pages), User Manual (17 pages), User Manual (11 pages), User Manual (14 pages), Quick Start Manual (20 pages), User Manual (23 pages), Manual (9 pages), User Manual (40 pages), User Manual (24 pages), User Manual (32 pages), Manual (42 pages), User Manual (20 pages)

Print Page
Philips 7000 series User Manual
Use DP and HDMI as input then use USB C as USB upstream.
Please follow the steps for the settings.
1. Connect the USB upstream cable from your duel devices to the "USB C" and "USB
up" port of this monitor at the same time.
The dual PC setup should look like this:
PC1: USB up as upstream and HDMI or DP cable for both video and audio transfer.
PC2: USB C as upstream (USB C-A) and DP or HDMI for both video and audio transfer.
For your convenience. Please use the table below as reference.
Source
HDMI or DP
DP or HDMI
2. Connect peripherals to the USB downstream port of this monitor.
1
OR
USB C-A Cable
OR
USBC1
USBC2
(DATA)
PC1
3. Enter to OSD menu. Go to KVM layer and select "USB C" to switch the control of
peripherals from one device to another. Simply repeat this step for switching the
control system using one set of peripheral.
Note
You can also adopt "MultiClient Integrated KVM" in PBP mode, when you enable PBP,
you can see two different sources projected to this monitor side by side simultaneously.
"MultiClient Integrated KVM" enhances your operation by using one set of peripherals
to control between in two systems through the OSD menu setting. Follow step3 as
mentioned above.
USB Upstream
USB up (USBC2)
USB C (USBC1)
2


 
 

1
OR
USB C-A Cable
OR
USBC1
USBC2
(DATA)
PC2
 

  
 
 

11