Philips AZ102C User Manual - Page 6

Browse online or download pdf User Manual for Stereo System Philips AZ102C. Philips AZ102C 15 pages. Cd soundmachine
Also for Philips AZ102C: Specifications (2 pages), User Manual (14 pages), Specifications (2 pages), User Manual (2 pages), User Manual (2 pages), User Manual (15 pages), User Manual (2 pages), User Manual (18 pages), User Manual (13 pages), Specifications (2 pages), User Manual (1 pages), Service Manual (11 pages)

Print Page

Power Supply

Whenever convenient, use the power supply

cord if you want to conserve battery life.

Make sure you remove the plug from the set

and wall outlet before inserting batteries.

Batteries (not included)

1 Open the battery door and insert 6 batteries,

type R-14, UM-2 or C-cells, (preferably

alkaline) with the correct polarity as indicated by

the "+" and "–" symbols inside the compartment.

2 Replace the battery door, making sure the

batteries are firmly and correctly in place.The

set is now ready to operate.

Batteries contain chemical substances, so

they should be disposed of properly.

•

Incorrect use of batteries can cause electrolyte

leakage and will corrode the compartment or

cause the batteries to burst:

•

Do not mix battery types: e.g. alkaline with

carbon zinc. Only use batteries of the same type

for the set.

•

When inserting new batteries, do not try to mix

old batteries with the new ones.

•

Remove the batteries if the set is not to be used

for a long time.

Using AC power

WARNING: Always check you have

completely switched off the set, before

you change or disconnect power supply.

1 Check if the power voltage, as shown on

the type plate located on the bottom

of the set, corresponds to your local power

supply. If it does not, consult your dealer or

service center.

2 Connect the power cord to the AC

MAINS~ inlet and the wall socket.The set is

now connected and ready for use.

3 To switch the set off completely, withdraw the

power cord from the wall socket.

4 Install the unit near the AC outlet and where

the AC power plug can be easily reached.

General Operation

•

Disconnect the power cord from the wall

socket to protect your set during heavy

thunderstorms. Children could seriously injure

themselves as the free end of the cable may

still be live if only the connector is removed

from the MAINS socket at the back of the

unit.

The type plate is located on the bottom

of the set.

Helpful hints:

–

To avoid unnecessary energy consumption,

always adjust the Source selector to OFF

after using the set.