Philips AZ102N User Manual - Page 10

Browse online or download pdf User Manual for Stereo System Philips AZ102N. Philips AZ102N 14 pages. Cd soundmachine
Also for Philips AZ102N: User Manual (15 pages), Specifications (2 pages), User Manual (2 pages), User Manual (2 pages), User Manual (2 pages), User Manual (18 pages), User Manual (13 pages), User Manual (1 pages), Service Manual (11 pages)

Philips AZ102N User Manual
AZ102_05_ENG_CCR
2010.3.30
Maintenance & Safety

CD player and CD handling

If the CD player cannot read CDs correctly,
use a cleaning CD to clean the lens before
taking the set to repair.
The lens of the CD player should never be
touched!
Sudden changes in the surrounding
temperature can cause condensation on the
lens of your CD player. Playing a CD is then
not possible. Do not attempt to clean the
lens but leave the set in a warm environment
until the moisture evaporates.
Always close the CD door to avoid dust on
the lens.
To clean the CD, wipe in a straight line from
the center towards the edge using a soft,
lint-free cloth. Do not use cleaning agents as
they may damage the disc.
Never write on a CD or attach any stickers
to it.
15:14
Page 10
(See 8)

Safety information

Place the set on a flat, hard and stable surface
so that the system does not tilt.
Where the MAINS plug or an appliance cou-
pler is used as the disconnect device, the dis-
connect device shall remain readily operable.
Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
The apparatus shall not be exposed to drip-
ping or splashing.
Adequate ventilation with a minimum gap of
15cm (6 inches) between the ventilation
holes and surrounding surfaces is necessary
to prevent heat build-up.
Do not cover the ventilation openings with
items such as newspapers, table-cloths, cur-
tains, etc.
No objects filled with liquids, such as vases,
shall be placed on the apparatus.
No naked flame sources, such as lighted can-
dles, should be placed on the apparatus.
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
To clean the set, use a dry cloth. Do not use
any cleaning agents containing alcohol, ammo-
nia, benzene or abrasives as these may harm
the housing.