Philips BM50B/10 User Manual - Page 24
Browse online or download pdf User Manual for Stereo System Philips BM50B/10. Philips BM50B/10 28 pages.
Print Page
•
The Bluetooth reception is poor. Move the
device closer to this unit or remove any
obstacle between them.
Bluetooth cannot be connected with this unit.
•
The device does not support the profiles
required for this unit.
•
The Bluetooth function of the device is
not enabled. Refer to the user manual of
the device to find out how to enable the
function.
•
This unit is not in pairing mode.
•
This unit is already connected with another
Bluetooth-enabled device. Disconnect that
device and then try again.
The paired mobile device connects and
disconnects constantly.
•
The Bluetooth reception is poor. Move the
device closer to this unit or remove any
obstacle between them.
•
Some mobile phones may connect and
disconnect constantly when you make
or end calls. This does not indicate any
malfunction of this unit.
•
For some devices, the Bluetooth
connection may be deactivated
automatically as a power-saving feature.
This does not indicate any malfunction of
this unit.
Timer does not work
•
Set the clock correctly.
•
Switch on the timer.
Clock/timer setting erased
•
Power has been interrupted or the power
cord has been disconnected. Reset the
clock/timer.
Group connection failed
•
Move slave speakers closer to the master.
•
You can only add slave speakers one by
one.
EN
22
•
You cannot group more than four speakers
with the master.
•
The master speaker may have switched to
single mode.
Occasional stuttering or breaking of music
streaming during group playback
•
If you experience music stuttering or
breaking of streaming, it could be that your
home Wi-Fi network is busy. Even though
Izzylink is independent from your home
Wi-Fi network, it uses Wi-Fi signals to
communicate between the speakers. Try
the following : 1) Reduce traffic on your
home Wi-Fi network, e.g. stop any large file
downloads or other content streaming on
your Wi-Fi network; 2) Reboot the Master
speaker, by unplugging it from the mains
and plugging it in again.