Toshiba TDP-MT500 Owner's Manual - Page 15
Browse online or download pdf Owner's Manual for Projector Toshiba TDP-MT500. Toshiba TDP-MT500 40 pages. Home projector
Also for Toshiba TDP-MT500: Owner's Manual (42 pages)
SETTING UP YOUR PROJECTOR
Setting up the screen
Set the screen perpendicular to the projector. If the screen can not be set perpendicularly, adjust the
projection angle of the projector. (See below.)
•
Adjust the screen or projector so that the shadow of the projector lens may be projected onto the center of the
screen.
•
Place the screen where it is projected from direct sunlight and other lights. Direct light onto the screen could
whiten the screen surface making the projected picture images hard to see.
Basic setup
Determine the distance from the screen to the projector according to the size of the picture images to be
projected. (See Page 16.)
Adjusting the projection angle
If a part of the projected picture image lies off the
edge of the screen, adjust the projection height or
the projection angle as follows:
1
1. Lift up the projector up to the desired projection
angle.
•
Set the projector within a tilt angle of 15 degrees.
2. Press up the left and right angle adjusting buttons.
3. Getting place the projector down at the angle you
adjusted.
4
4. By turning the angle adjusting foot (front) to the
left or right, make fine adjustment so that the pro-
jected image frame may be in parallel with the
sides of the screen.
When storing the projector:
Screen
2
Size of projected picture
images (Width)
A
Screen
Projector
5. Slowly set the projector down by pressing the left
and right angle-adjusting buttons.
•
It is also possible to adjust the projection angle by turn-
ing the angle adjusting foot (rear) to the left or right.
If the projected image frame is distorted
to a trapezoid:
If the screen and the projector are not set perpen-
dicular to each other, the projected image frame be-
comes trapezoidal. If it is not possible to bring them
into positions perpendicular to each other by any
mechanical adjustments, adjust the value for KEY-
STONE in the INSTALLATION menu. (See Page 28.)
•
If the "KEYSTONE" is applied, the aspect ratio may
not be adjusted correctly in some cases.
•
If the "KEYSTONE" is applied, the resolution of
the projected image will be reduced. Also, moire
fringes on fine-pattern images or drooping of
straight lines in the images will appear. Therefore,
try to set the screen and the projector perpendicu-
lar to each other as much as possible.
•
When changing the "KEYSTONE" setting, the im-
age may distort or disappear in a moment. How-
ever, this is not a malfunction.
B
A=B
15