Toshiba TDP-P75 Owner's Manual - Page 41
Browse online or download pdf Owner's Manual for Projector Toshiba TDP-P75. Toshiba TDP-P75 45 pages. 2,300 ansi-lumens contrast 2,000 : 1 ddr dmd technology
Also for Toshiba TDP-P75: Specifications (2 pages)
Print Page
English
Troubleshooting
Problem
The projector
does not turn
on.
No picture.
Image is
unstable.
Picture is
blurred.
Remote control
does not work
correctly
Cause
There is no power from the power
cord.
Attempting to turn the projector on
again during the cooling process.
The lamp cover is not securely
attached.
The video source is not turned on
or connected correctly.
The projector is not correctly
connected to the input source
device.
The input signal has not been
correctly selected.
The connection cables are not
securely connected to the
projector or the signal source.
The projection lens is not
correctly focused.
The projector and the screen are
not aligned properly.
The lens cap is still attached to
the lens
The batteries are out of power.
There is an obstacle between the
remote control and the projector.
You are too far away from the
projector.
Remedy
Plug the power cord into the AC inlet on
the projector, and plug the power cord
into to a power outlet. If the power outlet
has a switch, make sure it is switched
on.
p. 26
Wait until the cooling-down process is
completed.
Correctly attach the lamp cover.
Turn the video source on and check that
the signal cable is connected correctly.
p. 23
Check the connection.
Select the correct input signal with the
INPUT buttons on the remote control or
INPUT on the projector.
Correctly connect the cables to the
appropriate terminals.
Adjust the focus of the lens using the
focus ring.
p. 27
Adjust the projection angle and direction
as well as the height of this unit if
necessary.
p. 27
Remove the lens cap.
Replace both of the batteries with new
ones.
p. 19
Remove the obstacle.
Stand within 5 meters (16.4 feet) of the
projector.
p. 19
Troubleshooting
p. 23
p. 28
41