Toshiba TLP510E Service Manual - Page 10
Browse online or download pdf Service Manual for Projector Toshiba TLP510E. Toshiba TLP510E 33 pages. 3lcd data projector
Also for Toshiba TLP510E: Technical Training Manual (47 pages)
Print Page11. Fill a quick dry adhesive at joint of the LCD mount. In
this case, sufficient care will be necessary so that the
adhesive does not stick to the LCD panel surface or
any other parts.
Note:
• Use the adhesive available on the market as an epoxy
type two liquid mixture of equal amount.
Adhesive filling hole
Red/Blue LCD plate
Fig. 3-2-10
(3) Upper left
Movement of a cross hatch pattern with respect to a screen depending on an adjustment screw
(fundamental action).
Red-vertical direction adjustment
screw (3) (for the screen left side use).
Closing direction.
Blue-vertical direction adjustment
screw (2) (for the screen left side use).
Closing direction.
Red-left and right direction
adjustment screw (1)
Closing direction.
Blue-left and right direction
adjustment screw (1)
Loosen it direction.
Red-vertical direction adjustment
screw (3) (for the screen left side use).
Loosen it direction.
Blue-vertical direction adjustment
screw (2) (for the screen left side use).
Loosen it direction.
(2) Upper right
(1) Left
Red LCD plate
12. Leave the LCD block until the adhesive is hardened
for a required time. In this case, place a thin paper on
the LCD block to prevent dusts from entering.
13. When the adhesive is hardened, connect the FPC of
the LCD to the connector of the PC board, and turn on
the power. Check to see pixel deviation of the LCD.
14. Check to see dusts of the LCD. If dusts are found,
remove them.
15. Turn the power off. Remove all the cables connected
to the PC board and LCD panel, and remove the drive
PC board.
16. Mount the filter cover removed again. Tighten 4
screws, and close openings around the FPC section
with tape.
17. Mount the drive PC board again. Connect cables
disconnected from the drive PC board and the LCD
panel as they were connected.
18. Turn on the power and check operations.
(3) Upper left
(1) Right
Fig. 3-2-11
Fig. 3-2-12
1-8
(2) Upper right
Blue LCD plate
Red-vertical direction adjustment
screw (2) (for the screen right side use).
Closing direction.
Blue-vertical direction adjustment
screw (3) (for the screen right side use).
Closing direction.
Red-left and right direction
adjustment screw (1)
Loosen it direction.
Blue-left and right direction
adjustment screw (1)
Closing direction.
Red-vertical direction adjustment
screw (2) (for the screen right side use).
Loosen it direction.
Blue-vertical direction adjustment
screw (3) (for the screen right side use).
Loosen it direction.