3Com 3crwe875075a Configuration Manual - Page 9

Browse online or download pdf Configuration Manual for Wireless Access Point 3Com 3crwe875075a. 3Com 3crwe875075a 10 pages. Wds bridging and antenna installation
Also for 3Com 3crwe875075a: Conversion Manual (10 pages), Quick Start Manual (8 pages)

Print Page

Safety Notices

This equipment must be installed in compliance with local and national building codes, regulatory

restrictions, and FCC rules. For the safety of people and equipment, only professional network personnel

should install the equipment, cables, and antennas.

WARNING: Do not install the antennas near overhead power lines, electric light or power

circuits, or where it can come into contact with such circuits. Provide ten feet or more

clearance between the antenna and such power lines or circuits. Do not install the bridge

flush with the rooftop or wall. When installing the bridge, do not come into contact with

such circuits, which can cause serious injury or death. Follow local and national codes for

proper installation and grounding of antennas.

CAUTION: To comply with FCC radio frequency (RF) exposure limits, antennas should be

located at least two meters (six feet) or more from the bodies of all persons.

CAUTION: Do not install the bridge or connect and disconnect cables during periods of

lightning activity.

CAUTION: To avoid possible injury or damage to equipment, you must use either the

provided power supply or IEEE 802.3af compliant power supply equipment that is safety

certified according to UL, CSA, IEC, or other applicable national or international safety

requirements for the country of use. All references to power supply in this document refer

to equipment meeting these requirements.

CAUTION: It is the responsibility of the installer to ensure that the power over Ethernet (POE)

power supply is properly connected. Connection to any other device, such as a standard

Ethernet card or another POE supply, may result in permanent damage to equipment, electric

shock, or fire. Refer to the installation instructions for proper installation.

CAUTION: The 3Com power supply (part number 61-0107-000) input relies on a 16A rated

building fuse or circuit protector for short circuit protection of the line to neutral conductors.

CAUTION: If the antenna is installed outside, you need to use a lightning arrestor. 3Com

recommends the Huber Suhner lightning protector, item number 22652538. For more

information on this product, go to http://products.hubersuhner.com.

A lightning arrestor will not prevent damage from direct lightning strikes. It is extremely

important to ensure that the bridge is installed at least 1 meter (3 feet) below the top of the

grounded pole or mast.

CAUTION: Minimize damage from direct lightning strikes by mounting the antenna at least

1 Meter (3 feet) below the top of the mast.