CRU Dataport DE100 68-pin SCSI Manual
Browse online or download pdf Manual for Enclosure CRU Dataport DE100 68-pin SCSI. CRU Dataport DE100 68-pin SCSI 2 pages. Ultra320 68-pin removable scsi wide ultra320 drive enclosure
Print Page
DataPort
™
DE100 Ultra320 68-pin
Removable SCSI Wide Ultra320 Drive Enclosure
NOTES: For SCSI Ultra320 operation, the Ultra320 DE100 requires Ultra320
drives, Ultra320 HBA, and Ultra320-compliant cabling (internal and external).
Ultra320 DE100 can support Ultra320 implementations with a maximum of fifteen
(15) Ultra320 drives (Ultra320 repeater may be required).
Ultra320 DE100 receiving frames are indicated by their BLUE LED, while the
Ultra320 DE100 carriers are indicated by the Ultra320 logo.
Drive Installation Assembly
Cable Cover
(provided)
Disk Drive
(not included)
Power Cable
I/O Cable
ID Select Cable
Receiving
Frame
Receiving Frame Motherboard
Remote Unit ID Selection: Pins 1-8 of this connector are provided
for remote unit SCSI ID selection through the computer system. Remote
ID selection requires that the unit ID switch located on the inside of the
receiving frame be set to "0" (onboard ID selection is set with a switch
located on the inside of the receiving frame as shown in Figure 4).
Remote Activity LED: Pins 9 & 10 provide power to a remote LED
device activity indicator.
Enable Termination Power Connector (W2): A jumper is installed
at the factory and enables termination power to/from the SCSI bus.
NOTE: Do NOT remove this jumper!
Rugged, Reliable, Mobile, Secure
DC Power
Connector (P1)
(P1)
+5 GND 12
Drive
I/O Connector
Carrier
(J3)
#6-32 Phillips
Flat Hd. Screw
(6 Total)
Typical 2MM Drive ID Pin Configuration
Figure 3 illustrates a typical SCSI ID select connection to a drive with
2mm ID select pins. The wires on the wire harness connect to the
positive pin (or signal pins) on the disk drive. In some cases, the drive
manufacturer will label the signal pins as Pin 1, 3, 5, 7, (instead of 0,
1, 2, 3 as shown in figure below). Also, in some cases, the even-num-
bered Pins 2, 4, 6 are used for Ground.
Attach the ID select cable to the drive using the 2mm connectors. Align
the "ID0" pin with the black wire. Attach the 1.25mm connector on the
other end of the ID select cable to the 1.25mm connector (J3B) provided
on the signal distribution board, located inside the carrier. Refer to the
manufacturer's documentation to disable termination on the drive.
1-800-260-9800
W2 Jumper (factory
installed - do not remove)
{
Remote ID
ID0
ID1
Select
ID2
ID3
Ultra320
DE100
Figure 2: Receiving Frame Motherboard (rear view)
www.CRU-DataPort.com
TM
Option Pin
Connector
(W1)
Pins 11-22
Reserved