Crucial Audio Apollo 18 Operating Instructions Manual - Page 6

Browse online or download pdf Operating Instructions Manual for Accessories Crucial Audio Apollo 18. Crucial Audio Apollo 18 9 pages.

Print Page

POWER SWITCH:

FUSE HOLDER:

6-PIN CONNECTOR:

STOP:

AC POWER CABLE:

Left Side Panel

Main AC power switch. Switch to the "up" position to turn power on.

Main power fuse, make sure to replace with same type and value to prevent damage,

injury or fire. Fuse = T3A 3AGC

For use with Leslie® 122/142/ or 145/147 Type speaker.

WARNING!!! - Make sure to align six-pin connector with center alignment mark. The

protrosion or center mark must be aligned between Leslie® Connector's Pins 1 & 6.

Use only with specified/configured rotary speaker. Damage or injury could occur if

connected to a non-specified model. See unit's specific left side panel for

configuration type. Leslie® is a registered trademark of the Hammond Suzuki USA.

Crucial Audio® is not affiliated with the Hammond Suzuki USA.

This high-current 2 position Hi-Rose® connector provides a switched relay for the

Leslie® 5-pin stop motor accessory connector. The Crucial Audio® STOP cable

assembly required for this option. The STOP function can also be configured for

TrekII® EIS Relay system (specify configuration at time of order). This option doesn't

require an extra cable, and provides STOP function via the standard 6-Pin connector.

Please, note when using the EIS relay option that there is a 'learning mode'. The

Apollo-18 must be set to SLOW speed after initial warm up, and before the EIS relay

can recognize the STOP function. TrekII® is a registered trademark of the Trek II

Products, Inc. Crucial Audio® is not affiliated with TrekII Products, Inc.

3-Pin Grounded AC Cable for US domestic power. Export options are available.

Please, specify at time of order.