Crucial Audio DUB-5 Operating Instructions - Page 3

Browse online or download pdf Operating Instructions for Accessories Crucial Audio DUB-5. Crucial Audio DUB-5 5 pages.

Print Page

GND LIFT SWITCHES: Isolates balanced outputs' chassis ground, to reduce potential ground loops.

POLARITY/PHASE SWITCHES: Selects polarity/phase for Balanced Output on XLR connector.

BALANCED OUTS: Balanced Low-Impedance Out (polarity determined by Phase switch).

HI-Z OUTS: This unbalanced ¼" jack provides a high impendance output signal to your amplifier, mixing

console, or other effect units.

POST/PRE SWITCHES: Selects signal source for Hi-Z Out. Pre = pass thru/dry. Post = Tube Pre amp out.

INST/LINE SWITCHES: Engages a 15dB pad for the HI-Z input.

HI-Z INS: Unbalanced, high impedance ¼" input is optimized for a variety of input levels.

AC INPUT/FUSE HOLDER ASSEMBLY: Use only approved AC IEC Power Cable. CAUTION!!! Make sure

the voltage selector switch is set to the appropriate voltage: 115 or 230Vac 50/60Hz. Select

the proper main fuse according to the following table.

Line Voltage

LINE VOLTAGE SELECT SWITCH: This switch selects 115 or 230 AC Line Voltage. CAUTION!!! SET TO

THE PROPER LOCAL VOLTAGE! Damage can occur if this switch is not properly set.

POWER SWITCH: The Main Power Switch will illuminate when set to ON.

FRONT PANEL FUNCTIONS

115Vac

230Vac

Fuse

T2A 250V (SLO BLO) 5x20mm

T1A 250V (SLO BLO) 5x20mm