Cruise N Comfort MES 12 s Installation & Operating Instructions Manual

Browse online or download pdf Installation & Operating Instructions Manual for Air Conditioner Cruise N Comfort MES 12 s. Cruise N Comfort MES 12 s 7 pages. 12volt marine air conditioners

Print Page

MES 12/24 L/s 12Volt Marine Air Conditioners

Installation

1. Locate the area where the unit will be mounted and double check

that there are NO obstructions. Make sure that the location allows

for the cold air to return to the units evaporator.

2. Install the A/C control unit in a convenient location. Plug Control

Unit connector into A/C unit receptacle . fig.1

3. Connect ball valve and male threaded nipple to thru-hull pickup

GROCO 34 STH500W 1/2". Use teflon tape on fittings to ensure a

water tight seal. fig.2

4. Find a location under the hull in the transom area to mount the thru-

hull pickup. Make sure the fitting has the grate area facing forward

toward the bow and that the fitting will always be in the water when

the boat is underway. Note: Before drilling be certain there are no

obstructions. Install and seal with marine underwater sealant/glue.

ﬁg.3

5. Find a suitable location for the thru-hull water dump. fig.4 Install

and seal with marine underwater sealant/glue. Remember to install

at least 1 foot above the water line. Thru-hull water dump. fig.5

6. 6. Find a suitable location to install the water pump (under the water

line is recommended). Attach strainer to water pump per

manufacture instructions fig.6 . Run the 14 gauge power wires from

the unit to the water pump. The (RED) wire is the positive and the

(BLACK) is the negative power to the pump. These are 14 gauge

wires, and should be crimped with waterproof connectors to the

pump connector. Connect the pump connector to A/C unit. fig.8 The

water pump is required to flow 3 to 4 gallons per minute. The

current draw of the pump should not exceed 5 amps.  

Installation/Operating Instructions

Page