3Com WL-464 Installation Manual - Page 7

Browse online or download pdf Installation Manual for Wireless Access Point 3Com WL-464. 3Com WL-464 8 pages. 802.11a mini-pci radio module

Print Page

This device is intended only for OEM integrators under the following condition - The

antenna must be installed such that 30 cm is maintained between the antenna and users.

As long as the condition above is met, further transmitter test will not be required. However, the

OEM integrator is still responsible for testing their end-product for any additional compliance

requirements required with this module installed (for example, digital device emissions, PC

peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop

configurations or co-location with another transmitter), then the FCC authorization is no longer

considered valid and the FCC ID can not be used on the final product. In these circumstances, the

OEM integrator will be responsible for re-evaluating the end product (including the transmitter)

and obtaining a separate FCC authorization.

This transmitter module is authorized only for use in device where the antenna may be installed

such that 30 cm may be maintained between the antenna and

be labeled in a visible area with the following: "Contains TX FCC ID: O9CWL464".

The OEM integrator has to be aware not to provide information to the end user regarding how to

install or remove this RF module in the users manual of the end product which integrate this

module.

The users manual for end users must include the following information in a prominent location

" IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna

used for this transmitter must be installed to provide a separation distance of at least 30 cm from

all persons and must not be co-located or operating in conjunction with any other antenna or

transmitter".

If the end product integrating this module is going to be operated in 5.15 ~ 5.25GHz frequency

range, the warning statement in the user manual of the end product should include the restriction

of operating this device in indoor could void the user's authority to operate the equipment.

Industry Canada Statement

Operation is subject to the following two conditions:

1) this device may not cause interference and

2) this device must accept any interference, including interference that may cause undesired

operation of the device

This device has been designed to operate with an antenna having a maximum gain of 8 dB.

Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The

required antenna

impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be so

chosen that the EIRP is not more than required for successful communication.

End Product Labeling

Manual Information That Must be Included

users.

The final end product must