Dimplex SKG20 Installation And Operating Instructions - Page 2
Browse online or download pdf Installation And Operating Instructions for Stove Dimplex SKG20. Dimplex SKG20 4 pages. Stockbridge stove
Print Page
Operation
The controls are located behind the
Connect the fire to your electricity supply.
controls
Note: When either the remote control or the manual controls
are used, the neon's will come on for 3 seconds indicating
the relevant setting (see fig. 3).
Battery information
1.
Slide open the battery cover on the back of the remote
control
2.
Install two AAA batteries into the remote control (see
Fig. 4)
3.
Replace the battery cover.
Discard leaky batteries
Dispose of batteries in the proper manner according to
Provincial and local regulations. Any battery may leak electrolyte
if mixed with a different battery type, if inserted incorrectly, if all
the batteries are not replaced at the same time, if disposed of
in a fire or if an attempt is made to charge a battery not intended
to be recharged.
doors (see Fig. 2).
Fig. 2
neon's for indicating
the operation level
Fig. 3
Batteries
Fig. 4
On
Button
Off
Button
OFF
ON
Manual or Remote Operation
Setting
Operation
Flame effect
Press the 'ON' button once
Flame effect & 1kW heat
Press the 'ON' button again
Flame effect & 2kW heat
Press the 'ON' button again
To turn off any of the
Press the 'OFF' button once
settings
To increase or decrease the brightness of the fuel effect use the buttons as
shown in Fig. 5
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to
prevent damage due to overheating.
This can happen if the heat outlet was restricted in any way.
The heater will switch on once the obstruction has been
removed and the heater has cooled. If the cut-out continues
to operate intermittently, the heater should be switched off
and a service agent contacted.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Remote Control
Warning: it takes time for the
receiver to respond to the
transmitter. Do not press the
buttons more than once within
two seconds for correct
operation.
Increase
Brightness
Decrease
Brightness
Manual
Controls
Standby
Switch
Note : The Standby
Switch must first be
turned on to operate
either the manual or
the remote controls.
Fig. 5
Indication
Bottom Neon
Bottom &
Middle Neon
All 3 Neon's