Aeon Labs Aeotec Smart Switch 7 Quick Start Manual

Browse online or download pdf Quick Start Manual for Switch Aeon Labs Aeotec Smart Switch 7. Aeon Labs Aeotec Smart Switch 7 9 pages.

Print Page
Aeon Labs Aeotec Smart Switch 7 Quick Start Manual
Smart Switch 7 (ZW175)
Quickstart
This is a secure On/Off Power Switch for Europe. To run this device please connect it to your mains power
supply. This product supports Security 2 Command Class. While a Security S2 enabled Controller is needed in
order to fully use the security feature. This product can be included and operated in any Z-Wave network with
other Z-Wave certified devices from other manufacturers and/or other applications.
SmartStart Learn Mode:
1. SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present
on the product with a controller providing SmartStart inclusion. No further action is required and the SmartStart
product will be added automatically within 10 minutes of being switched on in the network vicinity.
2. Indicator Light will become flash white light for 1s indicating the product has been powered, and then become
flash blue light indicating SmartStart Learn Mode starts.
3.It will become constantly bright yellow light after being assigned a NodeID.
4. If Adding succeeds, it will bright blue light for 2s and become Load Indicator Mode.
5. If Adding fails, it will bright red light for 2s and turn back to breathing blue light and then start SmartStart Learn
Mode again.
Note: The label of QR Code on the product and package are used for SmartStart Inclusion.
The Z-Wave DSK Code is at bottom of the package. Please do not remove or damage them.