Dimplex GDC18RWA Instructions For Use Manual - Page 4
Browse online or download pdf Instructions For Use Manual for Air Conditioner Dimplex GDC18RWA. Dimplex GDC18RWA 9 pages. Inverter portable air conditioner
Also for Dimplex GDC18RWA: Maintenance Guidance (13 pages), Maintenance Guidance (11 pages)
Print Page
automatically.
3. If you press the "POWER" key before the timer is complete, the
set time will be cancelled and the unit will remain turned on.
TIMER-OFF: Similarly the timer-off is used to turn the unit off
automatically after the set time is over. Press the 'Timer' key
while the unit is turned on to activate turn-off timer and then set
the number of hours required.
8. SLEEP CONTROL
When setting the "sleep comfort" mode please ensure that you
FUNCTION
set the number of hours required by using the timer function. Once
the timer is set, the L.E.D. display will automatically return to your
current room temperature.
To increase the preset temperature - press the "Temp+" button
and for each press, the temperature will be increased by 1℃.
Likewise to set a lower temperature - press the "Temp-" button
and for each press, the temperature will be decreased by 1℃.
During the course of this cycle, to ensure maximum sleep
comfort, the micro-processor memory will raise the pre-set
temperature 0.5℃ each half hour to a maximum of 2℃ over two
hours and then maintain that temperature for the balance of the
time set.
The portable air conditioner is fitted with a 3 minute compressor
delay protection circuit which simply means that the compressor
requires 3 minutes to start - from either being switched on, or
when changing from "dehumidify" to any air conditioning mode.
Note: In sleep mode, the fan speed will automatically turn to 'Low' and the LED light will
automatically turn off after 1 minute. However, it can be turned on by pressing any key.
9."E7"
Indicates that the water tank is full. If so, please unplug the water
stopper at the back of the unit and then lean the unit to drain the
water out, the unit can then be restarted. If the error: E7 is
presented again, please contact your nearest service agent.
6
Note: Cooling function does not operate if the ambient temperature is over 43
REMOTE CONTROL FUNCTION
1. POWER
2. FUNC
3. TIMER
4. AUTO
5. HI
6. MID
7. LOW
8. SLEEP
9. TEMP.
℃
ON/OFF switch
Function ("Mode" selector)
Hourly programming
Automatic fan speed
High fan speed
Medium fan speed
Low fan speed
Night operation selector
Temperature selector
7
.