Aeon Labs Aeotec MULTISENSOR 6 User Manual - Page 10
Browse online or download pdf User Manual for Security Sensors Aeon Labs Aeotec MULTISENSOR 6. Aeon Labs Aeotec MULTISENSOR 6 11 pages.
Also for Aeon Labs Aeotec MULTISENSOR 6: Manual (14 pages)
2/26/2018
The LED on Multisensor 6 will now rapidly blink its Yellow/Orange LED while it is in its awake state. You may send in any
configurations or commands from your current gateway to configure your Multisensor 6.
4. Tap the Action Button on Multisensor 6 to put Multisensor 6 back to sleep, or wait 10 minutes. (recommended to manually put it
back to sleep to conserve battery life).
Testing Health Connectivity.
Note - Health test does not test for routing communication health, only tests for direct communication with your gateway to determine if
it has a healthy direct connection.
You can determine the health of your Multisensor 6s connectivity to your gateway using a manual button press, hold, and release
function which is indicated by the LED color.
1. Press and hold Multisensor 6 Action button
2. Wait until the RGB LED turns into a Purple Color
3. Release Multisensor 6 Action Button
The RGB LED will blink its Purple color while sending ping messages to your gateway, when it has finished, it will blink 1 of 3 colors:
Red = Bad Health
Yellow = Moderate Health
Green = Great Health
Be sure to watch for the blink, as it will only blink once very quickly.
Manually Factory Reset Multisensor 6.
This method is not fully advised unless your gateway has failed, and you do not yet have another gateway to perform a general unpair
on Multisensor 6.
1. Press and hold Multisensor 6 Action button
2. Wait until the RGB LED turns from:
- Yellow
- Purple
- Red - blinks faster and faster
- Green - You can let go here, it will continue to the next (Rainbow Cycle)
- Rainbow Cycle
3. If your MultiSensor has been successfully factory reset from its previous network, the RGB LED will be active with a colourful
gradient for 3 seconds. When you press the Action Button on MultiSensor, its green LED will blink. If the removal was unsuccessful,
the green LED will stay solid for a few seconds when you press the Action Button.
Additional information on other Gateways uses.
Smartthings Hub.
Smartthings hub has basic compatibility to the Multisensor 6, it does not allow you to access its advanced configuration functions
readily. In order to make full use of your Multisensor 6 to its fullest, you must install a custom device handler in order to access other
functions of the switch.
https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-
MultiSensor 6 user guide. : Aeotec by Aeon Labs
10/11