Pioneer DEH-1100MP Installation Manual
Browse online or download pdf Installation Manual for Car Receiver Pioneer DEH-1100MP. Pioneer DEH-1100MP 8 pages. Cd rds receiver
Also for Pioneer DEH-1100MP: Brochure (9 pages), Owner's Manual (24 pages)
CD RDS RECEIVER
REPRODUCTOR DE CD CON RECEPTOR RDS
CD RDS-EMPFÄNGER
AUTORADIO CD RDS
SINTOLETTORE CD RDS
CD RDS-ONTVANGER
CD RDS ПРИЕМНИК
DEH-1120MP
DEH-1100MPB
DEH-1100MP
DEH-112E
DEH-110E
Installation Manual
Manual de instalación
Installationsanleitung
Manuel d'installation
Manuale d'installazione
Installatiehandleiding
Руководство по установке
Printed in Thailand
Imprimé en Thaïlande
<QRD3015-A/N> EW
<KOKZX> <08H00000>
Installation
2
Secure the mounting sleeve by using a
Important
screwdriver to bend the metal tabs (90°)
! Check all connections and systems before
into place.
final installation.
! Do not use unauthorized parts. Use of un-
3
Install the unit.
authorized parts may cause malfunctions.
Dashboard
Rubber bush
! Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi-
cle.
! Do not install this unit where :
— it may interfere with operation of the vehi-
cle.
— it may cause injury to a passenger as a re-
sult of a sudden stop.
! The semiconductor laser will be damaged if it
Mounting sleeve
Screw
overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
Removing the unit
unit is installed at an angle of less than 60°.
1
Extend top and bottom of the trim ring
outwards to remove the trim ring. (When
60°
reattaching the trim ring, point the side
with a groove downwards and attach it.)
DIN front/rear mount
This unit can be properly installed either from
Trim ring
"Front" (conventional DIN front-mount) or
! It becomes easy to remove the trim ring if
"Rear" (DIN rear-mount installation, utilizing
the front panel is released.
threaded screw holes at the sides of unit chas-
sis). For details, refer to the following installa-
2
Insert the supplied extraction keys into
tion methods.
both sides of the unit until they click into
place.
DIN Front-mount
3
Pull the unit out of the dashboard.
Installation with the rubber bush
1
Insert the mounting sleeve into the
dashboard.
When installing in a shallow space, use a sup-
plied mounting sleeve. If there is enough
space behind the unit, use factory supplied
mounting sleeve.
En
Installation
DIN Rear-mount
Fastening the front panel
1
Extend top and bottom of the trim ring
If you do not plan to detach the front panel,
outwards to remove the trim ring. (When
the front panel can be fastened with supplied
reattaching the trim ring, point the side
screw.
with a groove downwards and attach it.)
Screw
Trim ring
! It becomes easy to remove the trim ring if
the front panel is released.
2
Determine the appropriate position
where the holes on the bracket and the
side of the unit match.
3
Tighten two screws on each side.
Screw
Mounting bracket
Dashboard or console
! Use either truss screws (5 mm × 8 mm) or
flush surface screws (5 mm × 9 mm), de-
pending on the shape of screw holes in the
bracket.
En