Pioneer DEH-12E Owner's Manual - Page 8
Browse online or download pdf Owner's Manual for Car Receiver Pioneer DEH-12E. Pioneer DEH-12E 18 pages. Cd receiver
Also for Pioneer DEH-12E: Owner's Manual (43 pages)
Print Page
Section
•
~onnections
No LCC
IJOSltron
-
Secure the wIring With cable clamps or ad-
heSive tape, \Nr-ap adhesive tape around
Will ng that comes Into contact With metal
paris to pl-otect the wll-ing,
-
Place all cables away from moving parts.
such as the gear shift and seat ralls,
-
Place all cables away from hot places.
such as near the heater outlet
-
Do not connect the yellow cable to the bat-
tery by passing It through the hole to the
engine compartment
-
Cover any disconnected cable connectors
with insulatlllg tape,
-
Do not shorten any cables.
-
Never cut the Insulation of the power cable
of thiS unit In or-der to share the power
with other deVices, The current capacity of
the cable Is !Imited.
-
Use a fuse of the r-ating pl'escribed
-
Never Wll-e the negative speaker cable di-
I-ectly to ground.
-
Nevel- band together negative cables of
multiple speakers,
•
When thiS unit is on, control Signals are sent
through tile blue/white cable, Connect thiS
cable to the system I-emote control of an exter-
nal power amp
01-
the vehlcle's auto-antenna
ay contm
l
ter-mlnal (max
300
Iilt\
12
\j
DC).
It
the vehicle IS equipped With a glass anten-
na, connect It to the antenna booster power
supply terminal.
•
Never- connect the blue/white cable to the
pOV\lel' temllnal of an extemal power amp,
Also, never connect It to the power terminal of
the auto antenna. Doing so may result
In
bat-
tel'y drain
01-
a malfunction.
AWARNING
•
Use speakers over 50 W (output value) and be-
tween
4
f2 to
8
f2 (Impedance,al
. Do not
use 1 f2 to
3
f2 speakers fOI- this unit
•
The black cable IS gl-ound. When Installing
this unit or power amp (sold separately). make
sUI-e to corlnect the glound wire first Ensure
that the ground wil-e is pmpel-Iy connected to
nletal parts of the cal's body The gr-oulld Wll-e
of the power amp and the one of thiS unit or
any other device must be connected to the car
separately with different sCI-ews. If the screw
for the ground wire loosens or falls out it
could result In fire. generation of smoke or
malfunction,
Ground wire
POWER AMP
~
I I
L
~~?!
1-6
6
\_
Other devices
Metal parts of car's body
(Another electronic
device in the car)
o
Important
•
When installing this unit In a vehicle without
all ACC (accessor-y) position on the Ignition
SWitch. failure to connect the I-ed cable to the
terminal that detects operation of the Ignition
key may r-esult In batter-y drall',
•
Use thiS unit with a 12-volt battel-y and Ilega-
tlve grounding only, Fallur-e to do so may I-esult
In
a
fll-e
01-
malfunction,
•
To prevent a shod-CII-CUIt. over-lleatlng
01
mal-
functlori, be SlHe to follow the dll-ections
IJe!ow
Disconnect the negative ternwlal of the
batter-y befor-e Installation,