Pioneer DEH-3200UB Operation Manual - Page 17

Browse online or download pdf Operation Manual for Car Receiver Pioneer DEH-3200UB. Pioneer DEH-3200UB 28 pages. Cd rds receiver
Also for Pioneer DEH-3200UB: Installation Manual (6 pages), Operation Manual (31 pages), Operation Manual (29 pages), Installation Manual (8 pages)

Print Page
Pioneer DEH-3200UB Operation Manual
Operating this unit
Loudness (loudness)
Loudness compensates for deficiencies in the low- and high-frequency ranges at low volume.
1. Press M.C. to display the setting mode.
2. Turn M.C. to select the desired setting.
OFF (off) – Low (low) – Mid (mid) – High (high)
3. Press M.C. to confirm the selection.
SW setting 1 (subwoofer on/off setting)
This unit is equipped with a subwoofer output which can be turned on or off.
1. Press M.C. to display the setting mode.
2. Turn M.C. to select the desired setting.
Normal (normal phase) – Reverse (reverse phase) – OFF (subwoofer off)
3. Press M.C. to confirm the selection.
SW setting 2 (subwoofer adjustment)
When the subwoofer output is on, you can adjust the cut-off frequency and the output
level of the subwoofer.
Only frequencies lower than those in the selected range are outputted from the
subwoofer.
1. Press M.C. to display the setting mode.
2. Press M.C. to cycle between cut-off frequency and output level of subwoofer.
3. Press M.C. to switch to cut-off frequency and then turn M.C. to select cut-off
frequency.
50Hz – 63Hz – 80Hz – 100Hz – 125Hz
4. Press M.C. to switch to output level and then turn M.C. to adjust output level.
Adjustment range: +6 to -24
HPF setting (high pass filter adjustment)
When you do not want low sounds from the subwoofer output frequency range to play
from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies
higher than those in the selected range are output from the front or rear speakers.
1. Press M.C. to display the setting mode.
2. Turn M.C. to select cut-off frequency.
OFF (off) – 50Hz – 63Hz – 80Hz – 100Hz – 125Hz
3. Press M.C. to confirm the selection.
Bass booster (bass boost)
1. Press M.C. to display the setting mode.
2. Turn M.C. to adjust the level.
Adjustment range: 0 to +6
3. Press M.C. to confirm the selection.
SLA (source level adjustment)
SLA (Source level adjustment) lets you adjust the volume level of each source to
prevent radical changes in volume when switching between sources.
• When selecting FM as the source, you cannot switch to SLA.
• Settings are based on the FM volume level, which remains unchanged.
Before adjusting source levels, compare the FM volume level with the level of the
source you wish to adjust.
• The AM volume level can also be adjusted with source level adjustments.
1. Press M.C. to display the setting mode.
2. Turn M.C. to adjust the source volume.
Adjustment range: +4 to –4
3. Press M.C. to confirm the selection.
Note
• Operation is complete even if the menu is cancelled before being confirmed.
17