Pioneer DEH-5300UB Owner's Manual - Page 9

Browse online or download pdf Owner's Manual for Car Receiver Pioneer DEH-5300UB. Pioneer DEH-5300UB 16 pages. Cd rds receiver
Also for Pioneer DEH-5300UB: Owner's Manual (49 pages)

Print Page
Pioneer DEH-5300UB Owner's Manual
Power amp (sold separately)
Perform
these connections when using the
optional amplifier.
~~
~@
I
®
G)
®:rtiJ~~
®
®
0
0
8
8
CD
System remote control
Connect to Blue/white cable.
®
Power amp (sold separately)
G)
Connect with RCA cables (sold separately)
@ To Rear output or subwoofer output
®
Rear speaker or subwoofer
@
To Front output
0
Front speaker[!)
Installation
c!r
Important
•
Check all connections and systems before
final installation.
•
Do not use unauthorized parts as this may
cause malfunctions.
•
Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi-
cle.·
Do not install this unit where:
-
it may interfere with operation of the vehi-
cle.
-
it may cause injury to a passenger as are-
sult of a sudden stop.
•
The semiconductor laser will be damaged if it
overheats. Install this unit away from hot
places such as near the heater outlet.
ill)
En
•
Optimum performance is obtained when the
unit is installed at an angle of less than 60°.
13_
DIN front/rear mount
This unit can be properly installed using either
@
front-mount or rear-mount installation.
Use commercially available parts when instal-
ling.
DIN Front-mount
Insert the mounting sleeve into the
dashboard.
For installation in shallow spaces, use the sup-
plied mounting sleeve. If there is enough
space, use the mounting sleeve that came
with the vehicle.
2
Secure the mounting sleeve by using a
screwdriver to bend the metal tabs (90°)
into place.
CD
Dashboard
®
Mounting sleeve
----------------------------------------~~~
( Installation
3
Install the unit as illustrated.
'
CD
Nut
®
Firewall or metal support
G)
Metal strap
@Screw
®
Screw (M4 x 8)
•
Make sure that the unit is installed securely in
place. An unstable installation may cause skip-
ping or other malfunctions.
DIN Rear-mount
Determine the appropriate position
where the holes on the bracket and the
side of the unit match.
•
Oo
2
Tighten two screws on each side.
CD.
CD
Screw
®
Mounting bracket
G)
Dash board or console
•
Use either truss (5 mm x 8 mm) or flush
surface (5 mm x 9 mm) screws, depending
on the bracket screw holes.
Removing the unit
1
Remove the trim ring.
CD
Trim ring
®
Notched tab
•
Releasing the front panel allows easier ac-
cess to the trim ring.
•
When reattaching the trim ring, point the
side with the notched tab down.
2
Insert the supplied extraction keys into
both sides of the unit until they click into
place.
Pull the unit out of the dashboard.
3
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
Removing the front panel to
For detai Is, refer to
protect your unit (rom theft
Re-attaching
and
the front panel
on page 5.
Fastening the front panel
If you do not plan to detach the front panel,
the front panel can be fastened with supplied
screws and holders.
En
--
Gil
)
m
::I
ce.
c;r
::I"
(ill