Pioneer DEH-7300BT Owner's Manual - Page 10

Browse online or download pdf Owner's Manual for Car Receiver Pioneer DEH-7300BT. Pioneer DEH-7300BT 23 pages. Cd rds receiver
Also for Pioneer DEH-7300BT: Operation Manual (29 pages), Installation Manual (29 pages)

Print Page

Section

Operating this unit

1 Press M.C. to display the setting mode.

2 Turn M.C. to select the equalizer.

DYNAMIC—VOCAL—NATURAL—CUSTOM

—FLAT—POWERFUL

3 Press M.C. to confirm the selection.

TONE CTRL (equalizer adjustment)

! Adjusted equalizer curve settings are stored in

CUSTOM.

1 Press M.C. to display the setting mode.

2 Press M.C. to select BASS (bass)/MID (mid)/

TREBLE (treble).

3 Turn M.C. to adjust the level.

Adjustment range: +6 to -6

LOUDNESS (loudness)

Loudness compensates for deficiencies in the low-

and high-frequency ranges at low volume.

1 Press M.C. to display the setting mode.

2 Turn M.C. to select the desired setting.

OFF (off)—LOW(low)—HIGH (high)

3 Press M.C. to confirm the selection.

SUBWOOFER1 (subwoofer on/off setting)

This unit is equipped with a subwoofer output

which can be turned on or off.

1 Press M.C. to display the setting mode.

2 Turn M.C. to select the desired setting.

NORMAL (normal phase)—REVERSE (reverse

phase)—OFF (subwoofer off)

3 Press M.C. to confirm the selection.

SUBWOOFER2 (subwoofer adjustment)

The cut-off frequency and output level can be ad-

justed when the subwoofer output is on.

Only frequencies lower than those in the selected

range are outputted from the subwoofer.

1 Press M.C. to display the setting mode.

2 Press M.C. to cycle between the cut-off fre-

quency and output level of the subwoofer.

Cut-off frequency (Cut-off frequency display

flashes.)—Output level (Output level display

flashes.)

3 Turn M.C. to select the desired setting.

Cut-off frequency: 50HZ—63HZ—80HZ—

100HZ—125HZ

Output level: -24 to +6

SLA (source level adjustment)

SLA (Source Level Adjustment) lets you adjust the

volume level of each source to prevent radical

changes in volume when switching between sour-

ces.

! Settings are based on the FM volume level,

which remains unchanged.

! The AM volume level can also be adjusted with

this function.

! When selecting FM as the source, you cannot

switch to SLA.

1 Press M.C. to display the setting mode.

2 Turn M.C. to adjust the source volume.

Adjustment range: +4 to –4

3 Press M.C. to confirm the selection.

Initial Settings

Press and hold S (SRC/OFF) until the unit

turns off.

Press M.C. and hold until function name

appears in the display.

Turn M.C. to select the initial setting.

After selecting, perform the following proce-

dures to set the initial setting.

Operating this unit

CLOCK SET (setting the clock)

1 Press M.C. to display the setting mode.

2 Press M.C. to select the segment of the clock

display you wish to set.

Hour—Minute

3 Turn M.C. to adjust the clock.

AUX (auxiliary input)

Activate this setting when using an auxiliary de-

vice connected to this unit.

1 Press M.C. to turn AUX on or off.

USB (plug and play)

This setting allows you to switch your source to

USB/iPod automatically.

1 Press M.C. to turn the plug and play function

on or off.

ON – When a USB storage device/iPod is con-

nected, depending on the type of device, the

source is automatically switched to USB/iPod

when you turn on the engine. If you disconnect

your USB storage device/iPod, this unit's

source is turned off.

OFF – When a USB storage device/iPod is con-

nected, the source is not switched to USB/

iPod automatically. Please change the source

to USB/iPod manually.

SW CONTROL (rear output and subwoofer set-

ting)

The rear speaker leads output and RCA output

can be used for full-range speaker or subwoofer

connection.

If you switch to REAR-SP :SW, you can connect a

rear speaker lead directly to a subwoofer without

using an auxiliary amp.

Initially, REAR-SP is set for rear full-range speaker

connection (FUL).

1 Press M.C. to display the setting mode.

2 Turn M.C. to change the output and press to

select.

REAR-SP—PREOUT

3 Turn M.C. to change the setting.

REAR-SP: FUL—SW

PREOUT: SW—REA

! Even if you change this setting, there will

be no output unless you turn the sub-

woofer output on (refer to SUBWOOFER1

(subwoofer on/off setting) on this page).

! If you change this setting, subwoofer out-

put in the audio menu will return to the fac-

tory settings.

DEMO (demo display setting)

1 Press M.C. to turn the demo display on or off.

SCROLL (scroll mode setting)

When ever scroll is set to ON, recorded text infor-

mation scrolls continuously in the display. Set to

OFF if you prefer the information to scroll just

once.

1 Press M.C. to turn the ever scroll on or off.

BT CLEAR (resetting the Bluetooth wireless tech-

nology module)