Pioneer X-CM66D Operating Instructions Manual - Page 28
Browse online or download pdf Operating Instructions Manual for Car Receiver Pioneer X-CM66D. Pioneer X-CM66D 39 pages. Cd receiver system
Print Page
10
Bluetooth
Note
• This unit will be displayed as "Pioneer X-CM66" on all
Bluetooth capable devices that you have.
Pairing will start.
• Place the Bluetooth capable device close to the unit.
• Please refer to the user's manual for your Bluetooth
capable device for details on when pairing can be
performed and the procedures required for pairing.
• When PIN code entry is requested, enter "0000." (This
unit does not accept any PIN code setting other than
"0000.")
4
Confirm on the Bluetooth capable device
that pairing has been completed.
If pairing with the Bluetooth capable device has been
completed correctly, the name of the Bluetooth capable
device will be displayed on the front panel of the unit. (Only
single-byte alphanumeric characters can be displayed. Any
character that cannot be displayed will be indicated by a
"∫".)
Listen to music on the unit from a
Bluetooth capable device
1
Press the
The unit will switch to Bluetooth input.
2
A Bluetooth connection will be created
between the Bluetooth capable device and the
unit.
Procedures for connecting to the unit should be performed
from the Bluetooth capable device.
• Please refer to the user's manual for your Bluetooth
capable device for details of the connection procedures.
3
Playback music from the Bluetooth capable
device.
Note
• When Bluetooth capable devise is not connected and
no operations have been performed for more than 20
minutes, the unit will automatically power off. In this
case it is required that the Auto power off is switched to
ON.
• Auto power off can be switched to ON/OFF (page 37).
28
En
®
Audio playback
.
Starting by Bluetooth
When this unit is in standby mode and operations to connect
with this unit are made from a device with Bluetooth that has
been paired with this unit, this unit turns on automatically with
Bluetooth input selected.
1
Press MENU on the remote control.
Press / until "Network Standby" is
2
displayed, then press ENTER.
Press / to switch auto power off setting
3
ON/OFF.
• Initial setting is set to ON.
Note
• Power consumption in the standby mode increases
when this function is ON.
Connection while in Network Standby mode with
Bluetooth capable device
When connection history (pairing has already been
conducted) with a Bluetooth capable device exists for the
unit during Network Standby, the unit can receive a
connection request directly from the connection history.
The unit will start using the Bluetooth function, and connect
with a Bluetooth capable device.
Even devices that have already been paired with this unit will
not connect during Network Standby in the following cases.
In such cases, delete pairing history from the Bluetooth
wireless technology device and perform pairing again.
• Up to 8 pairing history can be recorded with this unit. If
connecting to a Bluetooth wireless technology device
over 8 units, the oldest pairing history will be deleted.
• If the settings are reset to the factory setting, all pairing
history will be deleted.