Pioneer X-EM26 Operating Instructions Manual - Page 20
Browse online or download pdf Operating Instructions Manual for Car Receiver Pioneer X-EM26. Pioneer X-EM26 28 pages. System
Also for Pioneer X-EM26: Operating Instructions Manual (17 pages)
Print Page
08
Other features
Chapter 8:
Other features
Turn on automatically
You can set a time for automatic power on.
Note
• Make sure that you have set the clock before this setup.
1
In standby mode, press the CLOCK to
display time and then press and hold SLEEP/
TIMER.
[SOURCE] (time for auto power on) blinks.
2
Press :/9 to select [SOURCE].
3
Press SLEEP/TIMER.
The hour digits blink.
4
Press :/9 to set the hour.
5
Press SLEEP/TIMER again.
The minute digits blink.
6
Press :/9 to set the minute.
7
Press SLEEP/TIMER again.
8
Press :/9 to set the volume.
9
Press SLEEP/TIMER.
The clock time and [TIMER] are displayed.
• To deactivate the timer, display the time and then press
SLEEP/TIMER again.
• The power cannot be turned on while the timer is being
set. Finish setting the time, then turn on the power.
Setting the sleep timer
In the working mode, press SLEEP/TIMER repeatedly to
select a preset period (15, 30, 45, 60, 90 or 120 minutes).
When the sleep timer is activated, [SLEEP] is displayed on
the lower-right corner of the main display.
• To deactivate the sleep timer, press SLEEP/TIMER
repeatedly until [SLEEPOFF] is displayed.
20
En
Routing audio from other devices
Through the AUDIO IN socket
1
Connect a stereo mini-plug cable
(commercially available) to
• the AUDIO IN socket on the front panel of the main unit,
and
• the headphones socket on the external device (for
example, an MP3 player).
2
Press AUDIO IN on the remote control or
INPUT repeatedly on the main unit to switch the
source to [AUDIO IN].
3
Play the external device.
USB 500 mA charge
The USB terminal on this unit has a 500 mA output. A USB
device up to 500 mA can be connected and used/charged.
Setting and deactivating the DEMO
mode
You can set it to DEMO mode where the display scrolls the
words. When the power is off (standby mode) press and hold
∫. This will set the DEMO mode. To deactivate, press ∫
again.