Pioneer X-HX33 Operating Instruction - Page 29
Browse online or download pdf Operating Instruction for Receiver Pioneer X-HX33. Pioneer X-HX33 36 pages. Cd/receiver system
Print Page
6
Press the + or – button to set the
"Minute" for the playback start time,
then press the ENTER button.
7
Press the + or – button to set the
"Hour" for the playback end time, then
press the ENTER button.
8
Press the + or – button to set the
"Minute" for the playback end time,
then press the ENTER button.
This causes "OK" to flash in the display
panel.
Adjust the volume level if necessary.
9
Press the ENTER button.
A timer setting display appears so you can
check your setting.
Sometimes, a green lamp lights on the
TIMER button at this step. In such cases, be
sure to perform steps 10 and 11 below also.
10
Press the TIMER button repeatedly
until "WAKE UP" appears in the display
panel.
The TIMER button's green lamp goes on.
11
Press the POWER button (or the
STANDBY/ON button on the remote
control) to turn off the system's power.
The TIMER button should be lit.
Make sure that the system's power is off.
The Wake-up Timer will not operate unless
the system's power is off.
Now, playback will begin at the specified start
time and will end at the specified end time.
To cancel a timer setting (before completing
the setting)
Press the CANCEL button before pressing the ENTER
button at step 9 above.
If the specified playback start and end times
are the same
The TIMER button will not light after you press it at step
10, and the Wake-up Timer will not operate.
If the target disc is not loaded
For example, if you set up the Wake-up Timer to play a
CD (at step 2), then eject the CD before pressing the
TIMER button (at step 10), "NO DISC" appears in the
display panel and the Wake-up Timer will not operate.