Pioneer VSX-530-K Quick Start Manual - Page 5

Browse online or download pdf Quick Start Manual for Stereo Receiver Pioneer VSX-530-K. Pioneer VSX-530-K 17 pages. Pioneer vsx-1130-k; vsx-830-k; vsx-530-k av receivers
Also for Pioneer VSX-530-K: Reference Manual (27 pages), Service Manual (32 pages), Operating Instructions Manual (39 pages)

Print Page

Before you start

Put the batteries in the remote control.

Switch on the receiver and your TV.

Switch the TV input so that it connects to the

receiver.

Turn the subwoofer on and turn up the

volume.

Perform manual speaker setup.

Refer to "Manual speaker setup" in the CD-ROM operating

instructions

for details on how to perform the setup.

CAUTION

• Do not use or store batteries in direct sunlight or other excessively

hot place, such as inside a car or near a heater. This can cause

batteries to leak, overheat, explode or catch fire. It can also reduce

the life or performance of batteries.

• When inserting the batteries, make sure not to damage the

springs on the battery's  terminals. This can cause batteries to

leak or overheat.

• When disposing of used batteries, please comply with

governmental regulations or environmental public institution's

rules that apply in your country/area.

Basic playback

Playing a source

INPUT SELECT

Note

• When a sound can not be heard from center and rear speakers, press ALC/STANDARD or ADV SURR to change listening modes.

E.g.) Press the ADV SURR for several times to select EXT.STEREO.

• In order to listen to the audio from the source component that is connected to this receiver using a coaxial or an optical cable, choose the

C1 (coaxial) or O1 (optical) input. (Press SIG SEL.)

• If there's no sound from the subwoofer:

– When the front speaker is set to LARGE then, in some cases, no sound may come from the subwoofer. Change the front speaker setting to

SMALL or change the subwoofer to PLUS and the sound should be restored. If the front speaker has good low range playback capabilities

then it is recommended that you do not change the settings. (Refer to "Home Menu"  "Manual speaker setup" in the CD-ROM operating

instructions

for details)

• If the remote control isn't responding:

– In order to control the receiver using the remote control, first press

– In order to control TUNER or USB, first press TUNER or USB.

• If the power suddenly turns off:

– There is a possibly that the speaker cord's exposed wire is in contact with the rear panel or another exposed wire, triggering the protection

circuit. Firmly retwist the speaker's exposed wire and connect it ensuring that it isn't sticking out from the unit or the speaker terminal on

the speaker.

RECEIVER

LISTENING

MODE

VOLUME