Pioneer GM-D1004 Owner's Manual - Page 7
Browse online or download pdf Owner's Manual for Amplifier Pioneer GM-D1004. Pioneer GM-D1004 18 pages. Class d four-channel amplifier
Also for Pioneer GM-D1004: Owner's Manual (45 pages)
Print Page
Connecting the units
The point of connector
attachment/detachment
! Push in the connector until a clicking
sound, and connect it certainly.
! When you remove the connector, hold the
connector portion and pull it. When the
cord is pulled, the cord may be pulled out
from the connector.
About bridged mode
! Do not install or use this amplifier by wiring
speakers rated at 4 W (or lower) in parallel to
achieve a 2 W (or lower) bridged mode (Dia-
gram B).
Amplifier damage, smoke, and overheating
could result from improper bridging. The am-
plifier surface could also become hot to the
touch and minor burns could result.
To properly install or use a bridged mode and
achieve a 4 W load, wire two 8 W speakers in
parallel with Left + and Right * (Diagram A)
or use a single 4 W speaker.
In addition, refer to the speaker instruction
manual for information on the correct connec-
tion procedure.
! For any further enquiries, contact your local
authorized Pioneer dealer or customer
service.
About suitable
specification of speaker
Ensure speakers conform to the following
standards, otherwise there is a risk of fire,
smoke or damage. Speaker impedance is 2 W
to 8 W, or 4 W to 8 W for two-channel and other
bridge connections.
Subwoofer
Speaker channel
Power
Nominal input:
Four-channel output
Min. 45 W
Nominal input:
Two-channel output
Min. 90 W
Three-channel Front
Nominal input:
speaker out
Min. 45 W
Three-channel Rear
Nominal input:
speaker out
Min. 90 W
Other than subwoofer
Speaker channel
Power
Max. input:
Four-channel output
Min. 100 W
Max. input:
Two-channel output
Min. 200 W
Three-channel Front
Max. input:
speaker out
Min. 100 W
Three-channel Rear
Max. input:
speaker out
Min. 200 W
Connecting the speakers
The speaker output mode can be four-channel,
three-channel (stereo and mono) or two-chan-
nel (stereo or mono). Connect the speaker
leads based on the mode and the figures
shown below.
Section
03
7
En