Pioneer GM-D8704 Owner's Manual - Page 5

Browse online or download pdf Owner's Manual for Amplifier Pioneer GM-D8704. Pioneer GM-D8704 16 pages. Bridgeable four-channel power amplifier
Also for Pioneer GM-D8704: Service Manual (17 pages), Owner's Manual (16 pages)

Print Page

(_c_o_n_n_e_d_i_ng_th_e_un_i_ts_

___ )

The ground wires must be same size as the

battery wire.

Connect to metal body or chassis.

(J) Car stereo with RCA output jacks (sold sepa-

rately)

External output

If only one input plug is used, do not connect

anything to RCA input jack B.

Connecting wire with RCA pin plugs (sold se-

parately)

@) RCAinputjackA

RCA input jack B

Amplifier with RCA input jacks (sold sepa-

rately)

@) RCA output jack

Outputs the signal input to

CH A.

Speaker output terminals

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire.

@) System remote control wire (sold separately)

Connect male terminal of this wire to the sys-

tem remote control terminal of the car stereo.

The female terminal can be connected to the

auto-antenna relay control terminal. If the car

stereo lacks a system remote control terminal,

connect the male terminal to the power term-

inal via the ignition switch.

@) Fuse (30 A)

Front side

@) Rear side

@) Bass boost level remote control wire (5 m)

Bass boost level remote control

Note

INPUT SELECT

(input select) switch must be set.

For detai Is, see Setting the unit.

C!J

(

______

)

Before conneding the

amplifier

AwARNING

•

Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

•

Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

AcAUTION

•

Never shorten any wires, the protection circuit

may malfunction.

•

Never wire the speaker negative cable directly

to ground.

•

Never band together multiple speaker's nega-

tive cables.

•

If the system remote control wire of the ampli-

fier is connected to the power terminal via the

ignition switch (12V DC), the amplifier will re-

main on with the ignition whether the car

stereo is on or off, which may exhaust battery

if the engine is at rest or idling.

•

I nstal I and route the separately sold battery

wire as far as possible from the speaker wires.

Install and route the separately sold battery

wire, ground wire, speaker wires and the am-

plifier as far away as possible from the anten-

na, antenna cable and tuner.

C!J

About bridged mode

Diagram A - Proper

L(l)

Pioneer

Amplifier

Bridged Mode

Diagram B - Improper

Bridged Mode