Ariston AVXXF149 Instruction Booklet - Page 2

Browse online or download pdf Instruction Booklet for Washer Ariston AVXXF149. Ariston AVXXF149 12 pages. Ariston instruction manual washing machine avxxf149, avxxf137, avxxf129

Print Page

Installation

! Keep this instruction manual in a safe place for

future reference. Should the appliance be sold, trans-

ferred or moved, make sure the instruction manual

accompanies the washing machine to inform the new

owner as to its operation and

features.

! Read these instructions carefully: they contain vital

information on installation, use and safety.

Unpacking

1. Unpack the washing machine.

2. Check whether the washing machine has been

damaged during transport. If this is the case, do

not install it and contact your retailer.

Remove the transit fixings

IMPORTANT: Follow these instructions to remove the

TWO transit fixings.

Situated one either side of the

rear panel, BOTH transit bolts

MUST be removed before use.

! Failure to do so may damage

your machine.

It is important the transit bolt and

spacer come out intact (see pic).

1. Use a crosshead screwdriver

to remove the plastic cover.

2. Unscrew the bolt using a

13mm spanner.

3. STOP when 3 threads can be

seen.

4. Hold, slide and pull to

remove.

For safety, replace both plastic covers over the holes

left by removing the two bolts.

! Packaging materials are not childrens toys.

Levelling

1. Install the washing machine on a flat sturdy floor,

without resting it up against walls, cabinets etc.

2. Compensate for any unevenness by tightening or

loosening the adjustable front feet. The angle of

inclination, measured according to the worktop

must not exceed 2˚.

Levelling your appliance correctly will provide it with

stability and avoid any vibrations, noise and shifting

during operation. If it is placed on a fitted or loose

carpet, adjust the feet in such a way as to allow

enough room for ventilation beneath the washing

machine.

Water connection

Connecting the water inlet hose.

Remember that this is a cold-fill machine.

! Check that seal is in place

inside the hose end cap.

Before making the water connections to gas

thread, allow the water to run freely from the supply

tap until it is perfectly clear.

Screw the inlet end with the blue

cap onto the cold water supply

tap.

Turn the taps on and check for leaks:

tighten if necessary.

! Make sure there are no kinks or bends in the hose.

! The water pressure at the tap must be within the

values indicated in the Technical details table (next

page).

! If the water inlet hose is not long enough, contact a

specialist store or an authorised serviceman.

! Always use new hoses.

! Check the water hose at least once a year, replace

any that are cracked as worn hoses could split under

water pressure.