Pioneer 156729 Instruction Manual - Page 26
Browse online or download pdf Instruction Manual for CD Player Pioneer 156729. Pioneer 156729 28 pages.
Print Page
Troubleshooting
If you have any trouble using the CD Player, look for a solution in this section.
If you can't resolve the issue yourself, try resetting the CD Player before contacting the dealer from whom
you purchased this unit.
To reset the CD Player to its factory defaults, turn it on and, while holding down the [
button, press the [
Note that resetting the CD Player will delete your custom settings.
Power
Can't turn on the PD-30AE/PD-10AE.
• Make sure that the power cord is properly plugged into the wall outlet (page 14).
• Unplug the power cord from the wall outlet, wait five seconds or more, then plug it in again.
Audio
There's no sound.
• The PD-30AE/PD-10AE is not connected properly. Check all connections and correct as necessary.
• The wrong input source is selected on your amplifier. Check your amplifier's input source setting. Refer to
your amplifier's manual.
CD
Can't play a CD.
• The disc is upside down. Load the disc with the label-side facing up (page 16).
• The disc is dirty. Remove the disc and clean it (page 12).
• Condensation has formed inside the PD-30AE/PD-10AE. Unplug the power cord and leave the unit for two
to three hours in the room temperature unitl the condensation has evaporated.
• The disc is nonstandard. See "Disc Notes" on page 12.
CD playback skips.
• Install the PD-30AE/PD-10AE in a location that is free of vibration.
• The disc is dirty. Remove the disc and clean it (page 12).
• The disc is very scratched. Replace the disc.
Can't enter track numbers for memory playback.
• No such track on the CD. Enter another number (page 22).
It takes a long time to locate certain tracks.
• The disc is dirty. Remove the disc and clean it (page 12).
• The disc is very scratched. Replace the disc.
SETUP
Can't access the SETUP menu.
• If any track has been selected even when the PD-30AE/PD-10AE is stopped, you must place it into the full
stop state by pressing the [
Remote Controller
The remote controller does not work.
• There are no batteries in the remote controller. Install new batteries (page 11).
• The batteries are expired. Replace with new batteries (page 11).
• The batteries are installed incorrectly. Check the batteries and correct as necessary (page 11).
26
En-
] button. "Clear" will appear on the display.
;
] button before you can view all the SETUP menus.
∫
]
119