Pioneer CDS-9036ZT/ES Service Manual - Page 29
Browse online or download pdf Service Manual for CD Player Pioneer CDS-9036ZT/ES. Pioneer CDS-9036ZT/ES 45 pages. Car compact disc player
![Pioneer CDS-9036ZT/ES Service Manual](/uploads/products/server2/6629742/6629742.png)
6. ADJUSTMENT
6.1 CD
1)Precautions
• This unit uses a single power supply (+5V) for the reg-
ulator. The signal reference potential, therefore, is
connected to REFO(approx. 2.5V) instead of GND.
If REFO and GND are connected to each other by mis-
take during adjustments, not only will it be impossi-
ble to measure the potential correctly, but the servo
will malfunction and a severe shock will be applied to
the pick-up. To avoid this, take special note of the fol-
lowing.
Do not connect the negative probe of the measuring
equipment to REFO and GND together. It is especially
important not to connect the channel 1 negative
probe of the oscilloscope to REFO with the channel 2
negative probe connected to GND.
Since the frame of the measuring instrument is usual-
ly at the same potential as the negative probe, change
the frame of the measuring instrument to floating sta-
tus.
If by accident REFO comes in contact with GND,
immediately switch the regulator or power OFF.
• Always make sure the regulator is OFF when connect-
ing and disconnecting the various filters and wiring
required for measurements.
• Before proceeding to further adjustments and mea-
surements after switching regulator ON, let the player
run for about one minute to allow the circuits to stabi-
lize.
• Since the protective systems in the unit's software are
rendered inoperative in test mode, be very careful to
avoid mechanical and /or electrical shocks to the sys-
tem when making adjustment.
• Disc detection during loading and eject operations is
performed by means of a photo transistor in this
unit.Consequently, if the inside of the unit is exposed
to a strong light source when the outer casing is
removed for repairs or adjustment, the following mal-
functions may occur.
*During PLAY, even if the eject button is pressed,the
disc will not be ejected and the unit will remain in
the PLAY mode.
*The unit will not load a disc.
When the unit malfunctions this way, either re-posi-
tion the light source, move the unit or cover the
photo transistor.
• When loading and unloading discs during adjustment
procedures, always wait for the disc to be properly
clamped or ejected before pressing another key.
Otherwise, there is a risk of the actuator being
destroyed.
• Turn power off when pressing the button /FF or the
button REV key for focus search in the test mode. (Or
else lens may stick and the actuator may be dam-
aged.)
2)Test Mode
The CDS-9036ZT/ES is used together with a CD con-
trol unit(KEH-M8276ZT/X1N/ES) to make adjustment.
For adjustment, keys of the CD control unit are used.
For your reference, how to enter Test mode and oper-
ate keys when using a CD control unit are shown be-
low. The keys mentioned in the explanation of adjust-
ment are of a CD control unit(KEH-M8276ZT/X1N/ES).
• Entering Test mode
Short-circuit the probes indicated as "CD TEST" on
the substrate of the CDS-9036ZT/ES, then set ACC or
BACK UP to ON.
CONTROL UNIT(SIDE A)
CD TEST
Short-circuit these two probes.
• Cancelling Test mode
Set ACC or BACK UP to OFF.
• SINGLE/4TRK/10TRK/32TRK will continue to operate
even after the key is released.Tracking is closed the
moment C-MOVE is released.
• JUMP MODE resets to SINGLE as soon as power is
switched OFF.
CDS-9036ZT
29